Models > JCB2280HEB

JCB2280HEB Jenn-Air Refrigerator - Overview

Get Parts and Repair Help for JCB2280HEB

If you know the refrigerator repair part you need, you can browse the list of all parts on the JCB2280HEB, or you can search by name or part description. You can also find your part by where it is located on the JCB2280HEB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for JCB2280HEB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$109.46

Replacement Ice Maker

NOTE: This replacement ice maker mechanism does NOT come with a cover,shut off arm, a wire harness, or the mounting hardware. Must be ordered separately.

$2.52

Light Bulb - 40W

Sold individually.

$35.93

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$3.61

Door Closure Cam Kit

This part helps with the closing of the door and helps keep them in position.

$3.76

Crisper Frame Support

Note: If the wall anchor that this piece mounts on is broken, then the support is needed. (Order per Model#)

$258.25

Electronic Control Board

$14.89

Water Fill Cup and Bearing

$65.93

START-DEV

$2.70

Screw

This screw is sold individually.

$18.45

Light Switch

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Icemaker producing few or no cubes and often leaving "kling-ons" on ice tray

  • Customer: Bernie from Diamond Bar CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 509 of 520 people found this instruction helpful
Interior surface of ice tray felt rough & flaky (coating deteriorated) so cubes would not release.
Unplug appliance.
Remove timer cover by hand pressure @ edge.
Remove single attachment screw & bracket at lower front of icemaker.
Disconnect wiring harness from socket @ rear of compartment.
Tricky part was determining what type of con... read more

Freezer is cold, Refridgerator is not as cold as it should be

  • Customer: Russell from Hardinsburg KY
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 188 of 223 people found this instruction helpful
Having seen this problem before in other equipment so I had an idea where to look. Problem: the automatic defrost function was not operating. Looking through openings in the back panel of the freezer compartment, you could see the evaporator coils and fins were a solid chuck of ice. There are three logical components to check. Heater element, thermostat ... read more

Water overflowed ice maker turnning ice bucket into solid mass of ice

  • Customer: Harry from Grand Ledge MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 205 of 276 people found this instruction helpful
My ice maker has been shedding its non-stick coating for over a year. Within the last month of so, it started pouring water into the ice bucket below, turning it into a solid mass of ice. So I purchased a new ice maker assembly. I encountered two problems not mentioned in the 21 or so do-it-yourselfer repair stories that precede this one. First problem: o... read more