Models > JBP24BH2CT

JBP24BH2CT General Electric Range - Overview

Get Parts and Repair Help for JBP24BH2CT

If you know the range repair part you need, you can browse the list of all parts on the JBP24BH2CT, or you can search by name or part description. You can also find your part by where it is located on the JBP24BH2CT by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JBP24BH2CT parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JBP24BH2CT [Viewing 5 of 5]

$6.11

Drip Bowl - 6"

Sold individually.

$7.77

Drip Bowl - 8"

Sold individually.

$2.52

Light Bulb - 40W

Sold individually.

$49.62

Bake Element - Push On Terminals - 240V

This bake element is found on the bottom of the oven.

$11.25

Surface Burner Terminal Block Kit

This kit includes the female contact with wires, terminal block and mounting clip.

$19.54

Surface Burner Switch - 8" - 2500W

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$40.04

Surface Burner Element - 8"

This Y-frame eight inch surface burner element has five turns and a metallic center medallion.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$47.23

Broil Element

This broil element is found on the upper part of the oven cavity.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner bowls needed replacement

  • Customer: Tom from North Prairie WI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 459 of 461 people found this instruction helpful
Very easy repair, Pulled burner coil out, removed old burner bowl. Put in new burner bowl, plugged burner coil back in... easy as 1,2,3 read more

BURNER BOWL NEEDED REPLACED

  • Customer: Stephen from Knoxville TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 515 of 671 people found this instruction helpful
REMOVED BURNER ELEMENT AND PUT IN BOWL read more

Burner bowls were rusty and unsalvageable. Surface element wasn't heating.

  • Customer: Marguerite from Palm Harbour FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 217 of 279 people found this instruction helpful
Removed all surface elements, threw away old burner bowls, put the 3 older surface elements back in place and inserted the new element.

The burner bowls look great. Now I won't wait so long to replace.

Thanks. read more