Models > JB968BK5BB

JB968BK5BB General Electric Range - Overview

Get Parts and Repair Help for JB968BK5BB

If you know the range repair part you need, you can browse the list of all parts on the JB968BK5BB, or you can search by name or part description. You can also find your part by where it is located on the JB968BK5BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JB968BK5BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$27.12

Infinite Control Switch

$1.70

Screw

This screw is sold individually.

$11.48

Selector Knob

Sold Individually.

$53.18

Gasket

This oven door gasket prevents heat from escaping the oven cavity when in use.

$2.14

Door Pad

This is the door pad only. The trim is sold separately.

$5.55

Oven Light Socket - With Push In Receptacle

$2.36

Single Screw Only

Sold Individually.

$5.77

Foot - Leveller

$4.41

Light Cover

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 34 of 47 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

terminal block melted

  • Customer: jonathan from willow springs IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 22 people found this instruction helpful
The existing terminal block on my Ge oven/Range had melted due to a loose wire causing sparking and starting the plastic casing of the terminal block on fire and melting it, Part select made the part easy to find and had it at my house in 2 days. All I had to do was remove six screws to take the back sheet metal cover off of the oven. Unscrew the terminal ... read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 15 of 18 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more