Models > JB960KD1CC

JB960KD1CC General Electric Range - Overview

Get Parts and Repair Help for JB960KD1CC

If you know the range repair part you need, you can browse the list of all parts on the JB960KD1CC, or you can search by name or part description. You can also find your part by where it is located on the JB960KD1CC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JB960KD1CC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$27.12

Infinite Control Switch

$110.80

Dual Haliant Element with Limiter - 9" - 2500W

$1.27

SCREW

$5.77

Foot - Leveller

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$5.55

Oven Light Socket - With Push In Receptacle

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Large burner on dual element burned out

  • Customer: Scot from Oakland FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench(Adjustable)
  • 40 of 48 people found this instruction helpful
This was really easy, and pretty with no problems or issues It took me longer to write this than to do the actual installation. I used a digital camera to help me remember where things were, but a pen/paper works fine. Here's what I did:

1. Turn off the breaker for the cooktop.

2. Remove (2) 1/4" hex screws directly under cooktop. You m... read more

Inner glass window of oven cracked

  • Customer: Charles from Sharon MA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 32 of 34 people found this instruction helpful
1. Removed the oven door -- this is a little tricky -- you need to lift to small metal covers on the hinges, then pull the door up and out from the broil (half open position). Replace the door the same way. It is important to insert the hinges with the door in the "broil" position, and after verifying that the door is aligned and closes normally -- then li... read more

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 32 of 45 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more