Models > JB910TK2WW

JB910TK2WW General Electric Range - Overview

Get Parts and Repair Help for JB910TK2WW

If you know the range repair part you need, you can browse the list of all parts on the JB910TK2WW, or you can search by name or part description. You can also find your part by where it is located on the JB910TK2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JB910TK2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$27.12

Infinite Control Switch

$5.77

Foot - Leveller

$4.05

Control Knob

Sold individually. This knob accepts a double-flat shaft.

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$5.55

Oven Light Socket - With Push In Receptacle

$13.07

Door Bottom Channel Trim - White

$2.62

Screw

This screw is black in color and sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 32 of 45 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 15 of 18 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more

Range door bottom trim got rusty: a lousy design by GE.

  • Customer: Donald from Delmar NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 13 of 15 people found this instruction helpful
I used a screwdriver and pliers. A nut driver would have been helpful. Oven door is removeable for cleaning and maintenance, but it's heavy and awkward. It has to be laid face-side down to disassemble, so have a protected tabletop ready to avoid scratches. Side trim pieces have to come off to get access to bottom trim mounting screws. read more