Quick Question!

Have you ever purchased from PartSelect.com before?

Models > JB910KK2CC

JB910KK2CC General Electric Range - Overview

Get Parts and Repair Help for JB910KK2CC

If you know the range repair part you need, you can browse the list of all parts on the JB910KK2CC, or you can search by name or part description. You can also find your part by where it is located on the JB910KK2CC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JB910KK2CC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$10.89

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

$31.05

Infinite Control Switch

$9.78

Foot - Leveller

$7.05

Light Cover

$19.31

Broiler Pan - Large

Includes the pan and grate.

$43.56

WINDOW PACK ASM

$9.78

Oven Light Socket - With Push In Receptacle

$4.52

Door Pad

This is the door pad only. The trim is sold separately.

$2.91

Screw

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford, CT
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 56 of 77 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 25 of 30 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more

Switch failed

  • Customer: John from Fresno, CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 22 of 31 people found this instruction helpful
I turned off the circuit breaker and tested the cook top. I pulled the cook top out and laid a piece of plywood over the opening to work on the cook top and not scratch the granite counter top. The mistake I made was to turn the cook top upside down and separate the top from the housing. The dampening springs came off the burners and I could have damaged ... read more