Models > JB910BK1BB

JB910BK1BB General Electric Range - Overview

Get Parts and Repair Help for JB910BK1BB

If you know the range repair part you need, you can browse the list of all parts on the JB910BK1BB, or you can search by name or part description. You can also find your part by where it is located on the JB910BK1BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JB910BK1BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$27.12

Infinite Control Switch

$5.77

Foot - Leveller

$1.70

Screw

This screw is sold individually.

$2.36

Single Screw Only

Sold Individually.

$5.55

Oven Light Socket - With Push In Receptacle

$2.62

Screw

This screw is black in color and sold individually.

$4.41

Light Cover

$16.87

Broiler Pan - Large

Includes the pan and grate.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 32 of 43 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more

Oven wouldn't preheat above 300 degrees

  • Customer: Gerald from Cape Canaveral FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 14 of 16 people found this instruction helpful
Unplugged appliance and removed 5 screws on back of stove/oven and removed plate. Disconnected the sensor and unscrewed it on the inside of the oven. Pulled the cord through and replaced with new sensor. Replaced all parts and plugged in the appliance and tested. Worked great. read more

Switch failed

  • Customer: John from Fresno CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 13 of 18 people found this instruction helpful
I turned off the circuit breaker and tested the cook top. I pulled the cook top out and laid a piece of plywood over the opening to work on the cook top and not scratch the granite counter top. The mistake I made was to turn the cook top upside down and separate the top from the housing. The dampening springs came off the burners and I could have damaged ... read more