Models > JB600CD1CC

JB600CD1CC General Electric Range - Overview

Get Parts and Repair Help for JB600CD1CC

If you know the range repair part you need, you can browse the list of all parts on the JB600CD1CC, or you can search by name or part description. You can also find your part by where it is located on the JB600CD1CC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JB600CD1CC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JB600CD1CC [Viewing 5 of 5]

$2.58

Light Bulb - 40W

Sold individually.

$52.13

Bake Element - Push On Terminals - 240V

This bake element is found on the bottom of the oven.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$29.46

Oven Rack

Sold individually.

$4.48

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$47.23

Broil Element

This broil element is found on the upper part of the oven cavity.

$1.93

Screw

This screw is sold individually.

$22.36

Surface Burner Switch - 6" - 1560W

This switch controls the small burner on a range/stove top.

$2.14

Door Pad

This is the door pad only. The trim is sold separately.

$83.91

Large Haliant Burner with Limiter - 8"

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bake Element burned out, bunt like a sparkler.

  • Customer: Brad from Bedford KY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 150 of 159 people found this instruction helpful
Ordered the part on Friday, got it on Saturday, very impressive. Be sure to unplug the range or disconnect the power at the breaker box before any repairs are started.

The lower (Bake) element is held in by 2 screws. Remove them and gently pull out the element to remove the power wires connected to the element. These wires are very short and ther... read more

Inner glass window of oven cracked

  • Customer: Charles from Sharon MA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 34 of 36 people found this instruction helpful
1. Removed the oven door -- this is a little tricky -- you need to lift to small metal covers on the hinges, then pull the door up and out from the broil (half open position). Replace the door the same way. It is important to insert the hinges with the door in the "broil" position, and after verifying that the door is aligned and closes normally -- then li... read more

Bake Element fell apart

  • Customer: Ronald from Citrus Springs FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 34 of 36 people found this instruction helpful
Cut the Power! pull out stove remove the 4 screws in the back, disconnect the two wires from the element.Open oven door, remove racks and remove 2 screws holding the element in place. Replace element and the 2 retaining screws, replace racks.On the back of the oven connect the two wires and replace cover. Slide back in place and turn on the power. Done =) read more