Models > JB500CD1CC

JB500CD1CC General Electric Range - Overview

Get Parts and Repair Help for JB500CD1CC

If you know the range repair part you need, you can browse the list of all parts on the JB500CD1CC, or you can search by name or part description. You can also find your part by where it is located on the JB500CD1CC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for JB500CD1CC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the JB500CD1CC [Viewing 5 of 5]

$2.52

Light Bulb - 40W

Sold individually.

$49.62

Bake Element - Push On Terminals - 240V

This bake element is found on the bottom of the oven.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$12.82

Oven Sensor

This sensor detects the temperature within the oven cavity.

$47.23

Broil Element

This broil element is found on the upper part of the oven cavity.

$26.25

Oven Rack

Sold individually.

$22.36

Surface Burner Switch - 6" - 1560W

This switch controls the small burner on a range/stove top.

$1.27

SCREW

$83.91

Large Haliant Burner with Limiter - 8"

$5.77

Foot - Leveller

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bake Element burned out, bunt like a sparkler.

  • Customer: Brad from Bedford KY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 118 of 127 people found this instruction helpful
Ordered the part on Friday, got it on Saturday, very impressive. Be sure to unplug the range or disconnect the power at the breaker box before any repairs are started.

The lower (Bake) element is held in by 2 screws. Remove them and gently pull out the element to remove the power wires connected to the element. These wires are very short and ther... read more

Broiler element failed

  • Customer: paul from west grove PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 28 of 31 people found this instruction helpful
repair took about 30minutes total tiem..first turn off power to stove..then open oven removed racks..used nut drive to loosen top two screw hold element..then remove screw hold temp sensor element...then removed two screws holding broiler element...then removed the top screw ...then pulled element out about 7 inches to expose wire connection..held on with sp... read more

Oven would go in to a F2 Error

  • Customer: Peter from stamford CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 31 of 42 people found this instruction helpful
Removed six 1/4" hex nuts on rear of oven. Then through front/inside removed a single 1/4" hex nut to actually remove sensor. Unplug sensor connector, remove. Reversed steps, push oven back in place and plugged in. Tested oven function. read more