Models > J66RWP1WG

J66RWP1WG General Electric Range - Overview

Get Parts and Repair Help for J66RWP1WG

If you know the range repair part you need, you can browse the list of all parts on the J66RWP1WG, or you can search by name or part description. You can also find your part by where it is located on the J66RWP1WG by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the J66RWP1WG [Viewing 1 of 1]

$2.36

Single Screw Only

Sold Individually.

$55.52

Dual Infinite Control Switch - 3000W

$52.13

Selector Switch

$3.62

Secure Down Bracket

$77.96

Surface Element Switch - 1900W

$16.66

Switch Seal

This part goes between the infinite switch (under the cooktop) and the knob.

$6.24

Razor Scraper

This is sometimes used to clean glass stovetops.

$136.46

Surface Burner Element with Limiter - 8"

$92.27

Large Dual Element - 2500W

This dual element can be changed to be used as either a small or large burner. It comes with the element limit switch.

$4.27

SCREW

Common Symptoms of the J66RWP1WG [Viewing 1 of 80]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Cooktop Burner was always on High no matter what the setting on the Control

  • Customer: Raymond from Salt Point NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 15 of 18 people found this instruction helpful
1) Turn Power off at Circuit Breaker
2) Lift Cooktop out of counter top.
3) Remove all dials from controls by pulling straight up.
4) Remover glass plate which covers burners by removing
screws along outer edge.
5) Remove the two top screws from the control to be
replaced (this holds the infinite control to bracket)
... read more

Flat surface stovetop element was burned out

  • Customer: Leslie from Meridian MS
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 10 of 12 people found this instruction helpful
1. Removed brackets holding the cooktop in place.
2. Removed the cooktop.
3. Removed the screws holding the housing for the elements.
4. Removed bad element.
5 Connected new element.
6. Reassemble read more

The shaft on the selector switch broke.

  • Customer: David from Porter Ranch CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 6 of 7 people found this instruction helpful
You have to replace the switch if the shaft breaks (I think we hit it with a pot). This is a flat glass cook top. Turn off the power at the breaker box. I took the drawers out below the cook top and loosened the bracket holding the electrical conduit. That allowed me to push up the cook top from below. There is some adhesive but nothing hold it except its ow... read more