Models > J2S968BH2BB

J2S968BH2BB General Electric Range - Overview

Get Parts and Repair Help for J2S968BH2BB

If you know the range repair part you need, you can browse the list of all parts on the J2S968BH2BB, or you can search by name or part description. You can also find your part by where it is located on the J2S968BH2BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for J2S968BH2BB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$1.68

Grate Foot

Sold individually. The grate foot is located under the grate to protect the stove top.

$1.70

Screw

This screw is sold individually.

$4.27

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$13.89

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

$5.77

Foot - Leveller

$2.87

Front Drawer Support

$8.32

Halogen Light Bulb - 50W

This light bulb is used in the interior oven.

$1.27

SCREW

$32.82

Spark Module - (4+0)

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$53.82

Broil Element

This broil element is found on the roof of the oven.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 18 of 21 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

Broil (top) element replacement for oven

  • Customer: robert from pine valley CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 16 of 17 people found this instruction helpful
After turning the breaker off, using a 1/4 inch nut driver I removed all the clamp screws (5) holding the heating element in place. I then unplugged the element wire spades from the rear of oven and removed the old element. Installing the new one was simply going in reverse order. After plugging the new one in, I did however, use plyers to squeeze the connec... read more

terminal block melted

  • Customer: jonathan from willow springs IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 17 of 22 people found this instruction helpful
The existing terminal block on my Ge oven/Range had melted due to a loose wire causing sparking and starting the plastic casing of the terminal block on fire and melting it, Part select made the part easy to find and had it at my house in 2 days. All I had to do was remove six screws to take the back sheet metal cover off of the oven. Unscrew the terminal ... read more