Models > J2C968WEK3WW

J2C968WEK3WW General Electric Range - Overview

Get Parts and Repair Help for J2C968WEK3WW

If you know the range repair part you need, you can browse the list of all parts on the J2C968WEK3WW, or you can search by name or part description. You can also find your part by where it is located on the J2C968WEK3WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for J2C968WEK3WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$1.68

Grate Foot

Sold individually. The grate foot is located under the grate to protect the stove top.

Order within the next 12 hrs and your part ships today!
$4.48

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

Order within the next 12 hrs and your part ships today!
$1.93

Screw

This screw is sold individually.

Order within the next 12 hrs and your part ships today!
$14.73

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

Order within the next 12 hrs and your part ships today!
$13.04

Halogen Light Bulb - 50W

This light bulb is used in the interior oven.

Order within the next 12 hrs and your part ships today!
$3.00

Front Drawer Support

Order within the next 12 hrs and your part ships today!
$6.20

Foot - Leveller

Order within the next 12 hrs and your part ships today!
$35.21

Spark Module - (4+0)

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

Order within the next 12 hrs and your part ships today!
$3.41

Bottom Drawer Guide

Order within the next 12 hrs and your part ships today!
$17.95

Broiler Pan - Large

Includes the pan and grate.

Order within the next 12 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broil (top) element replacement for oven

  • Customer: robert from pine valley CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 17 of 18 people found this instruction helpful
After turning the breaker off, using a 1/4 inch nut driver I removed all the clamp screws (5) holding the heating element in place. I then unplugged the element wire spades from the rear of oven and removed the old element. Installing the new one was simply going in reverse order. After plugging the new one in, I did however, use plyers to squeeze the connec... read more

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 18 of 22 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

Plastic drawer support snapped off

  • Customer: Jeff Troiano from Sayville NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 14 of 14 people found this instruction helpful
The repair went very easy. The replacement part was designed differently than the original part. It installed on the rear of the drawer with a screw as the original snapped into the side. This was a bit confusing when researching and looking up the part online. read more