Quick Question!

Have you ever purchased from PartSelect.com before?

Models > J2C968WEK1WW

J2C968WEK1WW General Electric Range - Overview

Get Parts and Repair Help for J2C968WEK1WW

If you know the range repair part you need, you can browse the list of all parts on the J2C968WEK1WW, or you can search by name or part description. You can also find your part by where it is located on the J2C968WEK1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for J2C968WEK1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.59

Grate Foot

Sold individually. The grate foot is located under the grate to protect the stove top.

$15.64

Oven Sensor

This temperature sensor detects the temperature within the oven cavity.

$7.05

Rear Drawer Support

This rear drawer support comes with the installation screw. ***NOTE: There has been a factory design change and you must change both rear supports from side to rear.

$1.54

SCREW

$18.12

Broiler Pan - Large

Includes the pan and grate.

$42.65

WINDOW PACK ASM

$36.33

Spark Module - (4+0)

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$3.07

Screw

Sold Individually.

$9.78

Foot - Leveller

Sold individually.

$59.44

Broil Element

This broil element is found on the roof of the oven.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven was not coming up to temperature

  • Customer: Sean from Highlands Ranch, CO
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 34 of 39 people found this instruction helpful
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very e... read more

Plastic drawer support snapped off

  • Customer: Jeff Troiano from Sayville, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 24 of 24 people found this instruction helpful
The repair went very easy. The replacement part was designed differently than the original part. It installed on the rear of the drawer with a screw as the original snapped into the side. This was a bit confusing when researching and looking up the part online. read more

Aluminum Foil Bonded With Bottom

  • Customer: Linda from Oro Valley, AZ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 18 of 19 people found this instruction helpful
It was much easier than trying to remove the bonded aluminum foil from the false bottom/drip pan. Simply lift and remove oven front door, (see your manual), slide out false bottom and slide in new. For me it did take longer than 15 minutes, but that's because I was doing a thorough oven cleaning. The part was in the $50 range and well worth it. Why didn't an... read more