Models > ICS300WS00

ICS300WS00 Whirlpool Cooktop - Overview

Get Parts and Repair Help for ICS300WS00

If you know the cooktop repair part you need, you can browse the list of all parts on the ICS300WS00, or you can search by name or part description. You can also find your part by where it is located on the ICS300WS00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Torx Screw

7-18 x 3/4" - sold individually.

$2.70

Igniter Screw

This screw is sold individually.

$25.80

Burner Cap - Medium

Sold individually.

$15.15

Surface Igniter

Also known as Spark Electrode. This part helps your burner ignite and produce flame.

$4.46

Screw

$31.28

Small Burner Cap

$33.52

Burner Cap

$2.70

SCREW

$70.13

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$31.37

Large Burner Cap

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Top burners would not light. No "clicking" .

  • Customer: Carolyn from Bellingham MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 12 of 15 people found this instruction helpful
My husband and I replaced the igniter module, following directions we found online. We removed the old one, replaced it with the new one, and thankfully everything is working great! read more

Igniter problem on one gas burner

  • Customer: Roland from Houston TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 9 of 9 people found this instruction helpful
I had to remove the two separate components of the gas burner unit, each had two screws. I lifted then tilted the lower portion of the burner unit to allow access to the underside of the igniter. I removed the wire and then with an offset screwdriver I removed the single screw that held the igniter in place. I reversed the steps to install the replacement,... read more

gas burners would not automatically light when gas turned on

  • Customer: MICHAEL from LONGVIEW TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
I went online and discovered the repair method and schematic of the range. I removed the spark module after first removing the upper rear panel cover and replaced with the new part module ordered from your company and now the spark module operates all the gas elements when they are turned on thus lighting the gas burners. My mother in law was thrilled, as sh... read more