Models > ICNT22F93H (5B78A)

ICNT22F93H (5B78A) Admiral Refrigerator - Overview

Get Parts and Repair Help for ICNT22F93H

If you know the refrigerator repair part you need, you can browse the list of all parts on the ICNT22F93H, or you can search by name or part description. You can also find your part by where it is located on the ICNT22F93H by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ICNT22F93H parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Retaining Ring

$2.70

Screw

This screw is sold individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$2.70

Inlet Hose Gasket

$3.96

Compression Nut

$2.70

Screw

This is screw is sold individually.

$3.76

Plastic Tubing

1/4" Plastic tubing, 8 1/2 feet long.

$2.70

SCREW

Sold individually.

$17.75

Ice Bin Drive Ring

This part connects the ice auger to the motor through the bin.

$12.94

TRAY

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

the ice/water actuator switch burnt out and was stuck on.

  • Customer: Jon from Nampa ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
Removed the rubber cover over the actuator switch. Used a screwdriver to remove the switch, disconnected the wires. I then removed the switch from the mounting bracket using a small philips head screw driver. Installed the new switch on the mounting bracket then installed the switch onto the freezer door. The only difficult part was installing the rubbe... read more

The old ice maker was leaking water when it filled freezing the ice in the accumulation tray into one big lump.

  • Customer: Robert from Franklin TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 4 of 5 people found this instruction helpful
First, I read the instructions that came with the replacement ice maker, which I found confusing because they were apparently written to be installed in some other make of refrigerator. However, after removing the white plastic cover on the new unit and insuring that it was identical to the one that came with the refrigerator, I removed the old unit by first... read more

No ice was made

  • Customer: Gene from Highland Village TX
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 5 of 10 people found this instruction helpful
Removed power, removed the ice maker being held with three screws. Replaced with old unit. This box was so old that I robbed parts from the old and placed them on the new unit. Mkes ice very good. read more