This lid lock, also known as a door lock, is a genuine OEM replacement part for your washing machine. The lid lock keeps your washer lid closed during the washing cycle. If this part is broken, your w...
$83.87
In Stock
Order within the next 1 hr and 43 mins and your part ships today!
This drain pump assembly is for washers. Drain pump assembly removes water from the washer during the drain portion of the cycle. The assembly may include multiple parts; refer to your parts diagram f...
$48.21
In Stock
Order within the next 1 hr and 43 mins and your part ships today!
Order within the next 1 hr and 43 mins and your part ships today!
Questions And Answers for HTW240ASK0WS
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Tony
April 13, 2023
Does the spring come with the clutch?
For model number HTW240ASK0WS
Hi Tony,
Thank you for your question. The spring is sold separately. The part number for the spring clutch is PS11763251. We hope this helps!
At the end of the wash cycle the drain pump will kick in but it will not spin out. I can manually move the selector to drain and spin and it will then spin out.
For model number HTW240ASK0WS
Hi Stephen, thank you for getting in touch. Based on the description that you have provided, we would recommend replacing the control board, part number PS16874148, to solve the problem. It manages the washer's functions such as filling, washing, draining and spinning. We hope that helps!
Unit fills with water but will not agitate and drains very soon ( a few minutes) after filling. We replaced the lid sensor switch.
Any ideas
For model number HTW240ASK0WS
Hi Mike, thank you for reaching out. Based on our research, the issue is probably with the electronic control board, part number PS16874148. We suggest you replace the control board to fix the issue. We hope this helps!
Drain all the water out of the tub with a shop vac Remove rear drain hose and drained rest of water into a bucket Remove small rear panel (bottom left hand corner) where the drain hose connects Tipped washer up about 45 degrees to get underneath it - Supported it with a few paint cans Remove internal drain hose/clamps
... Read morefrom pump - w/ pliers Remove belt cover (gray plastic) with socket - 3 bolts Remove wire assembly plug from socket Remove old drain pump with socket - 3 bolts Install new drain pump - 3 bolts - plug wire assembly into socket Reinstall belt cover - 3 bolts Reinstall hose to drain pump (note panel will be inside washer) Feed drain hose panel through hole and reinstall - 1 nut Re attached drain hose to exterior drain plug You are done !
Very simple to repair. Be sure to drain the tub outside or into the sump pump then lay the washer on its side. The pump is right there on the bottom of the basket with 3 bolts. You will also need to remove the belt cover to get to the plug. So simple and saves you hundreds off repair man prices.
