Models > HDM1853BJ02

HDM1853BJ02 General Electric Microwave - Overview

Get Parts and Repair Help for HDM1853BJ02

If you know the microwave repair part you need, you can browse the list of all parts on the HDM1853BJ02, or you can search by name or part description. You can also find your part by where it is located on the HDM1853BJ02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for HDM1853BJ02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the HDM1853BJ02 [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.23

Halogen Light Bulb - 120V 20W

Sold individually.

$6.98

Light Bulb - 40W 130V

Sold individually.

$11.54

Light Socket - 250V 75W

$12.16

Grease Filter

This metallic vent hood filter collects grease particles in the air from cooking.

$6.62

FUSE

$8.54

Glass Light Lens

$44.62

Drive Motor

This motor rotates the glass turntable in the microwave and accepts a D-shaped shaft.

$8.54

Glass Turntable Coupler

This part accepts a D-shaped motor shaft.

$19.43

Secondary Door Switch

$34.18

Charcoal Filter

NOTE: The charcoal filter cannot be cleaned. It must be replaced. This metallic vent hood filter collects grease particles in the air from cooking.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

turntable made a loud noise

  • Customer: Dianne from Westminster CO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 363 of 366 people found this instruction helpful
First I unscrewed the screws that were holding the panel underneath. Then I removed the panel and removed the screws that held the turntable motor in place. Then replaced the old motor with the new and screwed everything back into place. read more

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 263 of 345 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

The turntable motor went out and was making a horrible sound when I started the microwave

  • Customer: Kim from Centerville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 141 of 207 people found this instruction helpful
First I unplugged the microwave. :) Then, I removed the 6 screws found underneath the microwave, which allowed the bottom piece to hang down so I could see the turntable motor. I took the two screws out holding the motor in place and pulled the electric connectors off the motor terminals. Then I got the new part from PartSelect.com, replaced the electrical c... read more