Quick Question!

Have you ever purchased from PartSelect.com before?

Models > HDA100S-45BA

HDA100S-45BA Hotpoint Dishwasher - Overview

Get Parts and Repair Help for HDA100S-45BA

If you know the dishwasher repair part you need, you can browse the list of all parts on the HDA100S-45BA, or you can search by name or part description. You can also find your part by where it is located on the HDA100S-45BA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for HDA100S-45BA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the HDA100S-45BA

[Viewing 3 of 3]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$0.77

RACK SLIDE END CAP

The rack slide end cap is the part that attaches to the rails of your upper dish rack and prevents the dishrack from sliding too far. If you find the dish rack is causing the door ...

$11.57

Upper Roller and Axle - Kit of 4

The dishwasher roller assembly attaches to the dishrack located in the upper level of the dishwasher. It allows the dishrack to slide and roll easily. If the upper rack keeps falling off the track in dishwasher, the door will not close, the door makes noises, and/ or dishes are not cleaning properly, then it is best to replace it for more security. A flat-blade screwdriver is the only tool needed for this installation. Slide open the upper dishwasher rack and remove retaining tab from both ends of the rack and slide it out. Locate the older roll assembly, remove it, and replace the rollers. Remember to put back the tabs on each side before sliding it back in. Make sure the dishwasher is off before starting this installation project.

$8.47

Corner Tub Baffle - Lower Left

The corner tub baffle may also be known as the door baffle and is a part used on your dishwasher. The left and right side baffle on your dishwasher should be installed and replaced...

$8.57

Corner Tub Baffle - Lower Right

This baffle fits the lower right hand corner of some dishwashers. It is black rubber and has a matching left hand lower corner baffle. It is recommended that you replace and install both left and right at the same time. It will become evident that this part needs to be replaced if you are experiencing leaking or lack of draining. This is a very easy repair that requires no tools. Open the dishwasher door and simply use your hands to remove the baffle found in the lower right hand side of the dishwasher. Clean out any dirt and insert your new one into place.

$15.63

Silverware Basket

The silverware basket, used for dishwashers, is in the bottom of the dishrack. The basket is used to hold eating utensils such as spoons, forks, and knives. If the basket is worn o...

$11.69

Interlock Switch

The interlock switch may also be referred to as a belt switch. This part is a simple on/off mechanism that prohibits the appliance from operating when the door is open. This is a part for your dryer. The interlock switch senses the door is shut and the dryer can begin. This part might need to be replaced if your dryer is not starting or is in process while the door is open. The black rectangular part of the switch is approximately 2 inches long and a 1/2-inch wide with two gold plates on either end. This is a genuine OEM part that is sourced right from the manufacturer.

$18.89

Drain Valve Shaft Seal

The drain valve shaft seal is a part for your dishwasher drain pump valve. This seal creates a watertight closure around the flapper valve shaft. This part can be accessed through ...

$3.52

Push On Nut

$9.64

Door Cable and Eyelet

This part is sold individually. It is recommended that both sides are changed when replacing one.

$10.64

Rinse Aid Fill Cap

This part helps keep the rinse aid the dispenser until its needed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The rollers on the upper rack broke

  • Customer: Carl from Fairfield, TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 507 of 514 people found this instruction helpful
There are eight guides that hold the rack rails in place. Use a Phillips screwdriver to remove the top two guides on each side in order to remove the rack from the dishwasher. The plastic axles on the rack and the rollers snap on. Use the hammer and punch to bend the metal clip on one end of the rail. Remove the plastic end piece then slide the rollers ... read more

Broken upper rack roller, rack kept falling off the track

  • Customer: Doug from Columbus, OH
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 386 of 390 people found this instruction helpful
Used the pliers to remove the broken roller. It came off in pieces. Slid new one on.

Cap on end of roller track was a bit of a challenge. It sort of twists & pulls off. read more

Water not draining from dishwasher

  • Customer: Mark from Morgan Hill, CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers, Socket set
  • 227 of 268 people found this instruction helpful
I had never done work on my dishwasher - I was a rookie in this area. Turns out the work itself was quite simple. Pulled the dishwasher out, turned it over, and was able to easily replace the motor and pump assembly. The drain tube was also an easy replace. A couple key notes:

1. I also purchased a new drain solenoid and impeller kit. Note that bo... read more