GWRE6270H0WW General Electric Washer - Instructions

The part came after 2 days..terrrific.. upon receipt, i attached the new one to the back of the washer and screwed. it all took about 5mins. My washer is back in business. I am very happy abouit it.
thank u.

Replace with new hose.

I figured out the problem,watched the video instructor and i did it,couln'd be easier guy h

the repair was easy. I will be call you again, thank you.

It was as simple as removing the front cover of the washer. After unpluging, using pliers, remove the two hoses on the pump and disconect the two power plug ins. Two bolts that mounted the pump to the frame of the washer were removed and the pump comes out. Re-install the same way with the new pump from partselect and it worked great.

ordered new one put on works like a new machine your repair website really helped.

I looked up what others said about the same problem. Took their advice, ordered the pump and it was installed in less than 30 minutes. This is the third time that we have ordered parts and have had excellent service. We usually get the parts the next day or at most two days. Instructions to repair are exactly like the customers say on the website. I tell all my friends and relatives about your site.Thanks PartSelect!

took off the front and replaced easily. I tested it and it worked! The trick to remove front panel is use 2 screwdrivers, one on side, one in front even to lid edge.

The repair was an easy fix. Since the washing machine was already away from the wall, all we had to do was push(in a screwing motion) the hose in the back of the washer. It sealed right up and we were doing laundry 15min later.

replaced drain hose and the water leak stopped. i could not see a hole in the old drain hose and thought i needed a new clothes washer but since a new drain hose was under $20. including shipping I figured it would not hurt to replace the old drain hose first. There must have been a microscopic split in the plastic drain hose because now it does not leak a drop. it was easy to replace and only took about 10 minutes from start to finish. Thanks.

Replace

just like the video showed/////only idid not kno the water would escape from one of the hoses when removed///video did not prepare me for this

My washer was full of water after it wouldn't drain as part of the wash cycle. I used a Wet/Dry vacuum to remove the water from the tub. Followed the video provided on this part page. When I pulled the hose from the wash tub to the pump at least a gallon of water that I was in the bottom of the tub and hose rushed into the base of the washer. It was an unexpected mess to clean up a the end of the job. Pump was fairly easy to remove from the washer, but reinstalling the hoses to the pump was slightly more challenging. The hose from the tub to the pump is about an inch too short to make this an easy fit. I had to have my wife hold the hose clamp open with the channel locks while I positioned pump onto the hose. After the hose was installed, the second hose was much easier to install. With the new pump the washer running like a champ!

"Thought" the belt was the problem - ordered new belt - waited for belt to arrive - opened washer. Belt was in perfect condition - problem is the clutch. Next time husband will verify problem before ordering parts.

Raise Lid on Washering Machine take broken one out
replace with new part.
Any 4 year old could have done it!

Thanks for your wonderful service!
Will recommend your company to friends.

Regards,

Fred