Models > GW395LEGZ3

GW395LEGZ3 Whirlpool Range - Overview

Get Parts and Repair Help for GW395LEGZ3

If you know the range repair part you need, you can browse the list of all parts on the GW395LEGZ3, or you can search by name or part description. You can also find your part by where it is located on the GW395LEGZ3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GW395LEGZ3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Light Bulb - 40W

Sold individually.


Inner Door Glass

Glass only.



This screw is sold individually.


Temperature Sensor

This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.


2 Piece Broiler Pan

The top of this part is now black.



This screw is sold individually.


Touch-Up Paint - White



Light Gasket

This part creates a seal around the light lens and bulb.


Oven Igniter

This part is used to light the oven for the bake or broil. Be very careful to not touch the black element part of this igniter as it is very fragile.


Single Drawer Roller

Used to slide the broiler drawer open and closed.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 110 of 139 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Inside door glass broke

  • Customer: MANNY from LIVERMORE CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 76 of 84 people found this instruction helpful
I removed the oven door by lifting it off with the hinges. Disassembled the door parts one at time making sure I remember where I removed the screws until I am able to get to the broken glass. The most difficult part is making sure that the insulation strip & the gasket stayed in place after I replaced the broken glass & doing the reverse process of installi... read more

Oven stopped working/Slow to ignite

  • Customer: John from Chicago IL
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 39 of 43 people found this instruction helpful
Although the ignitors glowed brilliant yellow I learned from an expert there are 2 fail modes. 1. that they break and don't glow well enough to ignite the gas or 2. they get resistive over the years and do not pass enough current to open the valve. This is important to know because the current passes through the ignitor before it gets to the valve. If the... read more