Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GW18G1WW

GW18G1WW Maytag Washer - Overview

Get Parts and Repair Help for GW18G1WW

If you know the washer repair part you need, you can browse the list of all parts on the GW18G1WW, or you can search by name or part description. You can also find your part by where it is located on the GW18G1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for GW18G1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.01

Screw

This screw is sold individually.

$5.15

Screw

This screw is sold individually.

$5.15

Hose Clamp

$5.15

Cover Screw

Sold individually.

$5.51

Hose Clamp

This hose clamp is sold individually.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$12.03

Leveling Leg and Pad

This part includes locknut.

$13.78

INLET HOSE

This hose can handle hot or cold water and is five feet long.

$10.64

Spray Paint - 12 oz. - White

$4.79

Screw

This screw is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Intermittent problem with lid switch, no high speed spin/pump out

  • Customer: Linda from La Porte, IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 30 of 43 people found this instruction helpful
Disconnect power, unsnap and raise machine top cover w/lid, remove old switch - two screws under lid, taking care to not drop loose actuator lever into machine. Remove control panel back and disconnect switch wire connector. Intall new switch, taking care to not drop loose actuator lever into machine, connect switch wires inside control panel. Replace pan... read more

Lid switch had deteriated over time and no longer made contact

  • Customer: James from Rochester, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 8 of 9 people found this instruction helpful
removed the screw holding the actuator, ordered the new part and replaced it when it arrived. Shipping was really fast and I even received it one day early. read more

Washer Spin Cycle Stopped

  • Customer: Diana from La Mirada, CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 6 of 8 people found this instruction helpful
Removed the screw from the side of the lid of the washer. Took off the old Lid Switch Actuator and screwed in the new one. Took a little elbow grease because the old screw was tight but no longer than 15 minutes tops. read more