Models > GT2482NKCW

GT2482NKCW Maytag Refrigerator - Overview

Get Parts and Repair Help for GT2482NKCW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GT2482NKCW, or you can search by name or part description. You can also find your part by where it is located on the GT2482NKCW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GT2482NKCW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$8.27

Shelf Retainer Bar End Cap

Sold individually.

$2.70

Screw

This screw is sold individually.

$3.76

Crisper Drawer Shelf Support

This crisper drawer shelf support is used for many refrigerators.

$6.98

Light Rocker Switch

$41.80

Lower Door Shelf Trim

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$105.64

Fresh Food Door Gasket

This white gasket is used to seal the door when closed to keep the cool air inside and the room air out.

$2.70

SCREW

Sold individually.

$4.46

Hinge Washer

$4.46

Lower Hinge Pin

This lower hinge pin is just over an inch long. It is black in color and is made of plastic. It is located on the bottom part of the door hinge.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

cocktails running out of ice

  • Customer: Craig from Westminster CA
  • Difficulty: Very Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 49 of 54 people found this instruction helpful
filled both ice cube trays up with water and placed in the freezer.. within hours my ice oproduction was doubled! no more warm cocktails : ) read more

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 41 of 49 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Door seal worn out, needed replacement

  • Customer: ROBERT from BASSETT VA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 13 of 14 people found this instruction helpful
To make instalation much easier, I removed the door and layed it on a table. I then remobved about 45 screws,removed the inner door section, removed the seal and installed new seal in reverse order being careful not to over tighten the screws. Having the door lying on the table made it much easier to place the gasket in place and make any minor adjustments. ... read more