Models > GT2127PEKS

GT2127PEKS Maytag Refrigerator - Overview

Get Parts and Repair Help for GT2127PEKS

If you know the refrigerator repair part you need, you can browse the list of all parts on the GT2127PEKS, or you can search by name or part description. You can also find your part by where it is located on the GT2127PEKS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GT2127PEKS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.64

Screw

Sold individually.

$2.70

SCREW

Sold individually.

$18.64

Light Switch

$15.21

Water Fill Cup and Bearing

$4.70

Compression Nut

$4.04

Evaporator Fan Blade

This fan blade attaches to the evaporator fan motor which is located in the back of the freezer.

$25.75

Thermostat with Clips

This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

$18.36

Plastic Tubing

1/4" Plastic tubing, 8 1/2 feet long.

$4.70

Fan Blade Clamp

$4.91

Water Hose Clamp

These tube clamps are sold individually. The screw is not included.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 69 of 82 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

No ice in ice trey

  • Customer: Wayne from Leesburg FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 53 of 61 people found this instruction helpful
The easiest thing to do was pull the ice make off. After taking the 3 screws out of the wall of the freezer, take a screwdriver (flathead) and push on the tab for the electrical plug and wiggle the cord out. Then you can take 3 screws out for the main cover and another 2 screws on the next cover. There's the part, pop it out and replace holding pins and star... read more

Door switch module wore out

  • Customer: Fred from Oceanport NJ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 24 of 30 people found this instruction helpful
Pull out old module...
Remove 2 wires...
Tape to inside wall [don't want them to fall down into side panel]..

Order new switch..

Fed Ex pkg came on 2nd day..

Install wires on switch...
Press into opening...
Check door light on..[OK]
.. Done read more