Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GT1522NXCW

GT1522NXCW Maytag Refrigerator - Overview

Get Parts and Repair Help for GT1522NXCW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GT1522NXCW, or you can search by name or part description. You can also find your part by where it is located on the GT1522NXCW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GT1522NXCW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

Screw

This screw is sold individually.

$11.11

Light Rocker Switch

This light rocker light switch is used in a number of household appliances. It is most often found in refrigerators and freezers. This is a simple mechanism that helps turn the light in your appliance on and off. If the door of your appliance is open the light should be on, and if the door is closed the light should be off. Your appliance door is opened and closed frequently, meaning the mechanism may wear out over time. It is not uncommon that this part will need to be replaced. You may need a putty knife to release the mounting tab and remove the faulty rocker switch. To install the new one, simply attach the wires and snap it into place in the liner of your refrigerator or freezer.

$9.47

Shelf Retainer Bar End Cap

The shelf retainer bar end cap is used to keep the retainer bar in place, and can be used on either the right or left hand side of the bar. This white, OEM end cap is approximately...

$20.01

Bimetal Defrost Thermostat

This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

$3.02

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$5.47

Crisper Drawer Shelf Support

This crisper drawer shelf support is used for many refrigerators. It is all white in color and is made entirely of plastic. This shelf support is less than an inch long.

$2.96

Screw

Sold individually.

$5.46

Lower Hinge Pin

This lower hinge pin is just over an inch long. It is black in color and is made of plastic. It is located on the bottom part of the door hinge.

$22.94

Center Hinge

$5.96

Hinge Washer

This hinge washer is an inch in diameter. It is all black in color and is made of plastic.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville, MO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 73 of 87 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

cocktails running out of ice

  • Customer: Craig from Westminster, CA
  • Difficulty: Very Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
  • 51 of 56 people found this instruction helpful
filled both ice cube trays up with water and placed in the freezer.. within hours my ice oproduction was doubled! no more warm cocktails : ) read more

water dripping inside fridge due to drain hole being frozen over wiith ice.

  • Customer: Edwin from Maplewood, NJ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 50 of 56 people found this instruction helpful
first I diagnosed the problem with the whirlpool do-it-yourself repair manual, which was very easy to understand. as per the repair manual, "this part located on the evaporator or the back of the liner is used during the defrost cycle. This bimetal senses the temperature from the evaporator. When the temperature reaches 50-70 degrees (F) the defrost bimetal... read more