Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GT1522NDFW

GT1522NDFW Maytag Refrigerator - Overview

Get Parts and Repair Help for GT1522NDFW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GT1522NDFW, or you can search by name or part description. You can also find your part by where it is located on the GT1522NDFW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GT1522NDFW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$25.56

BLADE-FAN

The fan blade is used to blow air over the condenser.

$65.53

Fresh Food Door Handle Kit

This kit comes with the handle in white, screws and screw covers. Note: If your door has been reversed so the handle is on the right side, this handle becomes the freezer handle. Use freezer handle if your refrigerator hand is on the right side

$7.77

CLIP- DEFR

$10.01

Butter Dish

Crisper Glass Shelf

Glass Only. Frame sold separately.

$51.15

Freezer Door Handle Kit

This kit comes with the handle in white, screws and screw covers. Note: If your door has been reversed so the handle is on the right side, this handle becomes the refrigerator handle.

$30.48

Dairy Door

$24.51

Screw

This screw is sold individually.

$5.41

Upper Hinge Shim

This upper hinge shim is just under two inches long. It is beige in color and is made of a thick paper. This shim is intended for use with refrigerator hinge assemblies.

Freezer Shelf Support Stud - rear

This part screws into the side of the wall in your fresh food compartment and supports a shelf.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville, MO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 55 of 67 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

cocktails running out of ice

  • Customer: Craig from Westminster, CA
  • Difficulty: Very Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
  • 51 of 56 people found this instruction helpful
filled both ice cube trays up with water and placed in the freezer.. within hours my ice oproduction was doubled! no more warm cocktails : ) read more

Coils frozen in refrigerator

  • Customer: robert from Martinez, GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 27 of 39 people found this instruction helpful
Cooling coils froze up. Removed back panel in freezer section. After thawing coils, manually advanced defrost timer to check if fan stopped and defrost (heat) strips energized. Fan did stop, but heating strips did not energize to thaw coils. Used electrical meter to determine circuit was open at defrost thermostat. Ordered replacement and installed in about ... read more