Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GS395LEHS4

GS395LEHS4 Whirlpool Range - Overview

Get Parts and Repair Help for GS395LEHS4

If you know the range repair part you need, you can browse the list of all parts on the GS395LEHS4, or you can search by name or part description. You can also find your part by where it is located on the GS395LEHS4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GS395LEHS4 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

Order within the next 8 hrs and your part ships today!
$5.15

SCREW

Sold individually.

Order within the next 8 hrs and your part ships today!
$7.20

Touch-Up Paint - White

18ml

Order within the next 8 hrs and your part ships today!
$39.18

Door Trim Kit - Black

This kit includes the 2 side pieces and 1 bottom piece. NOTE: This kit has been updated by the manufacturer. The lower screws are no longer needed for the side trim now locks in to the lower trim piece.

Order within the next 8 hrs and your part ships today!
$11.07

Spray Paint - 12 oz. - White

Order within the next 8 hrs and your part ships today!
$12.25

Anti-Tip Bracket Kit

This kit keeps your appliance from tipping. Comes with bracket, ring and 2 screws.

Order within the next 8 hrs and your part ships today!
$31.84

Lower Drawer Trim - Black

Order within the next 8 hrs and your part ships today!
$4.89

CLIP

$20.81

Spray Paint - Surperior Black

This is a 12oz can of black spray paint.

Order within the next 8 hrs and your part ships today!
$7.11

Hinge Pin Kit

Includes 4 hinge pins. Used at hinges to hold door open so the door can be lifted off.

Order within the next 8 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville, OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 124 of 160 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Front burner would not light. The igniter was cracked and the spark would not jump to the burner head.

  • Customer: Marilyn from Antioch, IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 41 of 41 people found this instruction helpful
I pulled the range from the wall and disconnected the power cord. I removed the grates, burner caps and the burners from the cooktop. Using a plastic putty knife, on either side of the range in the front I pushed the retaining clips to allow the cooktop to be raised. I used a short board to keep the cooktop open. I cut the wire leading to the broken igniter ... read more

surface burner igniter insulation broken, in-op

  • Customer: David from Reedley, CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 31 of 36 people found this instruction helpful
Broken ignitor wire had been previously removed to determine part number. Exact length was not availible (37"), but similiar unit (36") (one inch shorter) worked with zero problems. To re-install replacement wire/ignitor, I removed all four grates, and surface burners (allows top surface to pivot upwards.) Raised front of stove top surface by pushing in side... read more