Models > GS395LEGT7

GS395LEGT7 Whirlpool Range - Overview

Get Parts and Repair Help for GS395LEGT7

If you know the range repair part you need, you can browse the list of all parts on the GS395LEGT7, or you can search by name or part description. You can also find your part by where it is located on the GS395LEGT7 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GS395LEGT7 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$15.05

Control Knob

Sold individually. This black knob accepts a D-shaped shaft.

$14.98

Control Knob

Sold individually. This white knob can accept a D-shaped shaft.

$2.70

Torx Screw

7-18 x 3/4" - sold individually.

$3.76

Rear Drawer Glide

$2.70

Screw

This screw is sold individually.

$3.96

Front Drawer Glide

Sold individually.

$2.70

Igniter Screw

This screw is sold individually.

$43.62

Oven Rack

Sold individually.

$5.54

Touch-Up Paint - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

oven wouldn't heat

  • Customer: Ignatius from Hazelwood MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Wrench(Adjustable)
  • 48 of 50 people found this instruction helpful
My oven was misdiagnosed from an appliance repair company. They said my ignitors and spark module needed to be replaced. I did this myself and still nothing. The problem happened to be a defective gas valve.

First I unplugged the stove and shut off the gas supply. After I disconnected the flex hose and the 2 gas connections behind the stove, I... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more

spark igniter was weak and not lighting the flame.

  • Customer: Daniel from Needham MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set, Wrench(Adjustable)
  • 17 of 21 people found this instruction helpful
Open top oven door and remove the 2 front screws which hold the burners and controls to the frame. DO NOT lift the burners more than an inch or so to look inside. You WILL bend the gas lines in the back if you do. Pull out stove from the wall, shut off gas supply and disconnect hose if needed to have room to work. Remove top back panel and remove the 3 wires... read more