Models > GS395LEGQ5

GS395LEGQ5 Whirlpool Range - Overview

Get Parts and Repair Help for GS395LEGQ5

If you know the range repair part you need, you can browse the list of all parts on the GS395LEGQ5, or you can search by name or part description. You can also find your part by where it is located on the GS395LEGQ5 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GS395LEGQ5 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$12.92

Control Knob

Sold individually. This black knob accepts a D-shaped shaft.

$16.63

Control Knob

Sold individually. This white knob can accept a D-shaped shaft.

$2.70

Screw

This screw is sold individually.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$3.96

Rear Drawer Glide

$2.70

Torx Screw

7-18 x 3/4" - sold individually.

$13.02

Surface Burner Spark Igniter

This part helps your burner ignite and produce flame.

$2.70

Screw

$43.62

Oven Rack

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 68 of 87 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

oven wouldn't heat

  • Customer: Ignatius from Hazelwood MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Wrench(Adjustable)
  • 44 of 46 people found this instruction helpful
My oven was misdiagnosed from an appliance repair company. They said my ignitors and spark module needed to be replaced. I did this myself and still nothing. The problem happened to be a defective gas valve.

First I unplugged the stove and shut off the gas supply. After I disconnected the flex hose and the 2 gas connections behind the stove, I... read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more