Models > GS395LEGQ0

GS395LEGQ0 Whirlpool Range - Overview

Get Parts and Repair Help for GS395LEGQ0

If you know the range repair part you need, you can browse the list of all parts on the GS395LEGQ0, or you can search by name or part description. You can also find your part by where it is located on the GS395LEGQ0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GS395LEGQ0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$3.76

Rear Drawer Glide

$2.70

Screw

This screw is sold individually.

$3.96

Front Drawer Glide

Sold individually.

$43.62

Oven Rack

Sold individually.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$2.70

SCREW

This screw is sold individually.

$2.70

Screw

$3.84

SCREW

$33.68

Oven Door Trim Kit

This white oven door trim set contains three pieces: two for the sides of the door and one for the bottom. The screws are sold separately.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 85 of 109 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Front burner would not light. The igniter was cracked and the spark would not jump to the burner head.

  • Customer: Marilyn from Antioch IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 33 of 33 people found this instruction helpful
I pulled the range from the wall and disconnected the power cord. I removed the grates, burner caps and the burners from the cooktop. Using a plastic putty knife, on either side of the range in the front I pushed the retaining clips to allow the cooktop to be raised. I used a short board to keep the cooktop open. I cut the wire leading to the broken igniter ... read more

surface burner igniter insulation broken, in-op

  • Customer: David from Reedley CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 26 of 30 people found this instruction helpful
Broken ignitor wire had been previously removed to determine part number. Exact length was not availible (37"), but similiar unit (36") (one inch shorter) worked with zero problems. To re-install replacement wire/ignitor, I removed all four grates, and surface burners (allows top surface to pivot upwards.) Raised front of stove top surface by pushing in side... read more