Models > GS2787EKDA

GS2787EKDA Maytag Refrigerator - Overview

Get Parts and Repair Help for GS2787EKDA

If you know the refrigerator repair part you need, you can browse the list of all parts on the GS2787EKDA, or you can search by name or part description. You can also find your part by where it is located on the GS2787EKDA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GS2787EKDA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$49.48

Water Filter

This Puri-Clean water filter will fit most Maytag and Jenn Air refrigerators that have a screw-in filter. Sold individually.

$14.89

Water Fill Cup and Bearing

$13.46

Limit Switch - 2 Terminal

This limit switch is located in the ice/water dispenser section. The switch pictured here is black, though this type of switch is also available in white.

$3.86

Lower Hinge Pin

This lower hinge pin is almost two inches long. It is made entirely of plastic and it is all black in color.

$18.45

Light Switch

$3.82

SCREW

$3.91

Natural Door Closer

$4.46

Ice Chute Door Return Spring

Sold Individually.

$3.96

Compression Nut

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 63 of 76 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

Refrigerator Filter needed replacing

  • Customer: Bruce from Alfred Station NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 51 of 58 people found this instruction helpful
Turn counter clockwise, following the remove arrow on the filter, until it stops. Wiggle and pull down on the filter until it comes off. Put date sticker on new filter to remember when it was replaced. Align the lines on the filter and push it up where the old one was and turn it clockwise until it stops, following the install arrow. Close the door and p... read more

No ice in ice trey

  • Customer: Wayne from Leesburg FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 45 of 52 people found this instruction helpful
The easiest thing to do was pull the ice make off. After taking the 3 screws out of the wall of the freezer, take a screwdriver (flathead) and push on the tab for the electrical plug and wiggle the cord out. Then you can take 3 screws out for the main cover and another 2 screws on the next cover. There's the part, pop it out and replace holding pins and star... read more