Models > GS2727GEHW

GS2727GEHW Maytag Refrigerator - Overview

Get Parts and Repair Help for GS2727GEHW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GS2727GEHW, or you can search by name or part description. You can also find your part by where it is located on the GS2727GEHW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GS2727GEHW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Screw

This screw is sold individually.

$3.96

Crisper Drawer Shelf Support

This crisper drawer shelf support is used for many refrigerators.

$56.00

Water Filter

This Puri-Clean water filter will fit most Maytag and Jenn Air refrigerators that have a screw-in filter.

$18.45

Light Switch

$18.32

Water Fill Cup and Bearing

$4.06

Lower Hinge Pin

This lower hinge pin is almost two inches long. It is made entirely of plastic and it is all black in color.

$12.68

Limit Switch - 2 Terminal

This limit switch is located in the ice/water dispenser section. The switch pictured here is black, though this type of switch is also available in white.

$15.80

Actuator Pad

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water.

$4.46

Rack Wheel

Sold individually.

$4.46

Door Shelf Bucket Stop

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ice maker and water dispenser would stick on. Would have to oprn door to stop flow of water or ice

  • Customer: David from Springdale OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 49 of 55 people found this instruction helpful
I replaced the actuator switch and rubber pad with the switch actuator.
I had attempted to repair previously without replacing the pad but the problem continued. I put up with the problem for a long time waiting for the opportunity to get to the appliance parts store but their hours are hard to deal with and work myself. I was able to find the part eas... read more

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 48 of 61 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

Refrigerator Filter needed replacing

  • Customer: Bruce from Alfred Station NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 45 of 51 people found this instruction helpful
Turn counter clockwise, following the remove arrow on the filter, until it stops. Wiggle and pull down on the filter until it comes off. Put date sticker on new filter to remember when it was replaced. Align the lines on the filter and push it up where the old one was and turn it clockwise until it stops, following the install arrow. Close the door and p... read more