Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GS2727EEDW

GS2727EEDW Maytag Refrigerator - Overview

Get Parts and Repair Help for GS2727EEDW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GS2727EEDW, or you can search by name or part description. You can also find your part by where it is located on the GS2727EEDW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GS2727EEDW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

Screw

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this sc...

Order within the next 11 hrs and your part ships today!
$22.07

Light Switch

This light switch may also be known as a refrigerator door switch or a light switch kit, and is compatible with your refrigerator. The function of the refrigerator door switch is to turn on the light when your fridge door is open, and to make sure it is off when your refrigerator door is closed. The reason you would need to replace this part is if your light is not turning on when your door is open. For this repair, you will need a putty knife, and a small flat-blade screwdriver.

Order within the next 11 hrs and your part ships today!
$4.87

Screw

Sold individually.

Order within the next 11 hrs and your part ships today!
$5.27

Lower Hinge Pin

This is a lower hinge pin for your refrigerator door. This hinge helps your door open and close easily by allowing it to pivot. You will need to replace your lower hinge pin if your refrigerator door will not open or close properly. This part is almost two inches high, one inch wide, and roughly two inches long. You will need a Phillips screwdriver and a 5/16 nut driver to replace this pin. It is made entirely of plastic and is all black.

Order within the next 11 hrs and your part ships today!
$28.84

Icemaker Shut Off Arm

When the icemaker shut off arm is high enough the icemaker will shut off and no more ice will be made until the level of ice in the bin drops. Also, the icemaker can be turned off ...

Order within the next 11 hrs and your part ships today!
$24.54

BLADE-FAN

The fan blade is used to blow air over the condenser.

Order within the next 11 hrs and your part ships today!
$2.98

Screw

Sold individually.

Order within the next 11 hrs and your part ships today!
$70.52

FILTER7, SINGLE

Order within the next 11 hrs and your part ships today!
$15.38

Limit Switch - 2 Terminal

This limit switch, also known as a dispenser switch, is used in refrigerators and freezers. The function of this part is to control the dispensing of ice or water when the dispense...

Order within the next 11 hrs and your part ships today!
$30.64

Thermostat Order 542369 Cement

The ice maker thermostat, also known as the cycling thermostat, controls and regulates the ice maker ejection cycle by monitoring the temperature inside the freezer to determine when to release the ice into the bin and start the ice making cycle again. If your ice maker is making unusual noises, or if the ice maker is not making or dispensing ice, there could be an issue with the thermostat. Before you begin this repair, make sure the power is disconnected from your refrigerator, and that any food that may spoil is safely stored. This is an OEM part and is sourced directly from the manufacturer. This thermostat is sold individually, and comes with two attachment clips.

Order within the next 11 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 95 of 115 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

Refrigerator Filter needed replacing

  • Customer: Bruce from Alfred Station, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 87 of 97 people found this instruction helpful
Turn counter clockwise, following the remove arrow on the filter, until it stops. Wiggle and pull down on the filter until it comes off. Put date sticker on new filter to remember when it was replaced. Align the lines on the filter and push it up where the old one was and turn it clockwise until it stops, following the install arrow. Close the door and p... read more

Ice maker and water dispenser would stick on. Would have to oprn door to stop flow of water or ice

  • Customer: David from Springdale, OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 80 of 87 people found this instruction helpful
I replaced the actuator switch and rubber pad with the switch actuator.
I had attempted to repair previously without replacing the pad but the problem continued. I put up with the problem for a long time waiting for the opportunity to get to the appliance parts store but their hours are hard to deal with and work myself. I was able to find the part eas... read more