Models > GS2726CEHQ

GS2726CEHQ Maytag Refrigerator - Overview

Get Parts and Repair Help for GS2726CEHQ

If you know the refrigerator repair part you need, you can browse the list of all parts on the GS2726CEHQ, or you can search by name or part description. You can also find your part by where it is located on the GS2726CEHQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GS2726CEHQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$10.48

Ice Chute Door

This ice door is used to seal off the ice chute when not in use.

$3.86

Lower Hinge Pin

This lower hinge pin is almost two inches long. It is made entirely of plastic and it is all black in color.

$15.79

Water Fill Cup and Bearing

$12.68

Limit Switch - 2 Terminal

This limit switch is located in the ice/water dispenser section. The switch pictured here is black, though this type of switch is also available in white.

$15.80

Actuator Pad

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water.

$4.46

Ice Chute Door Return Spring

Sold Individually.

$2.70

SCREW

Sold individually.

$3.83

SCREW

$24.48

Thermostat with Clips

This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ice maker and water dispenser would stick on. Would have to oprn door to stop flow of water or ice

  • Customer: David from Springdale OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 57 of 63 people found this instruction helpful
I replaced the actuator switch and rubber pad with the switch actuator.
I had attempted to repair previously without replacing the pad but the problem continued. I put up with the problem for a long time waiting for the opportunity to get to the appliance parts store but their hours are hard to deal with and work myself. I was able to find the part eas... read more

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 58 of 71 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

Ice dispenser cover flap was broken.

  • Customer: Philip from Plantation FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 45 of 45 people found this instruction helpful
First I unpluged the refrigerator, then I removed the drip shelf (slides out). Then removed the two screws hidden by the drip shelf. Then I removed the control panel by pulling out on the bottom then lifting slightly to to expose the ribbon cable. The circuit boards you see at this point will deliver an electrical shock if the refrigerator is plugged in. I... read more