Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GS2526CEDW

GS2526CEDW Maytag Refrigerator - Overview

Get Parts and Repair Help for GS2526CEDW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GS2526CEDW, or you can search by name or part description. You can also find your part by where it is located on the GS2526CEDW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GS2526CEDW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

Screw

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this sc...

Order within the next 9 hrs and your part ships today!
$11.11

Light Rocker Switch

This light rocker light switch is used in a number of household appliances. It is most often found in refrigerators and freezers. This is a simple mechanism that helps turn the light in your appliance on and off. If the door of your appliance is open the light should be on, and if the door is closed the light should be off. Your appliance door is opened and closed frequently, meaning the mechanism may wear out over time. It is not uncommon that this part will need to be replaced. You may need a putty knife to release the mounting tab and remove the faulty rocker switch. To install the new one, simply attach the wires and snap it into place in the liner of your refrigerator or freezer.

Order within the next 9 hrs and your part ships today!
$22.07

Light Switch

This light switch may also be known as a refrigerator door switch or a light switch kit, and is compatible with your refrigerator. The function of the refrigerator door switch is t...

Order within the next 9 hrs and your part ships today!
$5.27

Lower Hinge Pin

This is a lower hinge pin for your refrigerator door. This hinge helps your door open and close easily by allowing it to pivot. You will need to replace your lower hinge pin if your refrigerator door will not open or close properly. This part is almost two inches high, one inch wide, and roughly two inches long. You will need a Phillips screwdriver and a 5/16 nut driver to replace this pin. It is made entirely of plastic and is all black.

Order within the next 9 hrs and your part ships today!
$28.84

Icemaker Shut Off Arm

When the icemaker shut off arm is high enough the icemaker will shut off and no more ice will be made until the level of ice in the bin drops. Also, the icemaker can be turned off ...

Order within the next 9 hrs and your part ships today!
$24.54

BLADE-FAN

The fan blade is used to blow air over the condenser.

Order within the next 9 hrs and your part ships today!
$2.96

Screw

Sold individually.

Order within the next 9 hrs and your part ships today!
$15.38

Limit Switch - 2 Terminal

This limit switch, also known as a dispenser switch, is used in refrigerators and freezers. The function of this part is to control the dispensing of ice or water when the dispenser lever is pressed. The switch is over 1 inch long and comes in white or black. It is made from plastic and metal. If your refrigerator is having trouble dispensing water or there is leakage, it is best to replace the switch. The tools needed for this repair are a #15 torks, #2 Phillips screwdriver, #1 Phillips screwdriver, and needle nose pliers. Remember to unplug your appliance from the power source before beginning this installation project and refer to the manual for further installation instructions.

Order within the next 9 hrs and your part ships today!
$17.88

Water Fill Cup and Bearing

This refrigerator ice maker fill cup dispenses the water into the ice cube mold during the fill cycle. Replacing the water fill cup is a possible solution if you notice that the ic...

Order within the next 9 hrs and your part ships today!
$4.63

Natural Door Closer

Order within the next 9 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 95 of 115 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

Lights inside refrigerator not working

  • Customer: Clint from Rayville, MO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 73 of 87 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

No ice in ice trey

  • Customer: Wayne from Leesburg, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 73 of 88 people found this instruction helpful
The easiest thing to do was pull the ice make off. After taking the 3 screws out of the wall of the freezer, take a screwdriver (flathead) and push on the tab for the electrical plug and wiggle the cord out. Then you can take 3 screws out for the main cover and another 2 screws on the next cover. There's the part, pop it out and replace holding pins and star... read more