Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GS2325GEKW

GS2325GEKW Maytag Refrigerator - Overview

Get Parts and Repair Help for GS2325GEKW

If you know the refrigerator repair part you need, you can browse the list of all parts on the GS2325GEKW, or you can search by name or part description. You can also find your part by where it is located on the GS2325GEKW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GS2325GEKW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$71.08

Water Filter

Sold individually. This part has been updated by the manufacturer. It may appear different but will still function the same.

$7.60

Water Filter Bypass Cap

This cap is used when bypassing the filter.

$8.88

Crisper Frame Support

Note: If the wall anchor that this piece mounts on is broken, then the support is needed. (Order per Model#)

$22.51

Light Switch

This part turns on the light when the door is opened.

$7.60

Door Closure Cam Kit

This part helps with the closing of the door and helps keep them in position.

$16.74

Water Fill Cup and Bearing

$16.53

Icemaker Helix End Cap - white

This helix end cap is almost four inches in diameter. It is all white in color and is made of plastic. This end cap is used in a refrigerator's icemaker.

$15.47

Fan Blade

Used with Evaporator Fan Motors.

$21.97

Light Switch

$15.83

Butterfly Handle Mount

This mount is used to connect the handle and trim together. Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

light on to order water filter

  • Customer: Douglas from Byron, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 673 of 717 people found this instruction helpful
Pressed in the end of the filter cover, lowered it down part way. Twisted the old filter 1/4 turn and removed it. Set in the sink to drain. Inserted new filter and twisted it to lock. closed cover. Done. Total time @ 1 Minute. read more

Freezer is cold, Refridgerator is not as cold as it should be

  • Customer: Russell from Hardinsburg, KY
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 261 of 318 people found this instruction helpful
Having seen this problem before in other equipment so I had an idea where to look. Problem: the automatic defrost function was not operating. Looking through openings in the back panel of the freezer compartment, you could see the evaporator coils and fins were a solid chuck of ice. There are three logical components to check. Heater element, thermostat ... read more

Removing the existing filter by rotating as directed and then dislodging from 'docking' station proved difficult. Turns out, the old filter is under a bit of vacuum pressure and getting the unit to separate or release was a challenge.

  • Customer: Jake from Novato, CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 196 of 286 people found this instruction helpful
I removed the drop-down outer housing by gently prying the sides of the two pivot pins at the rear. This gave me move 'room' to grip and slightly rotate then pull the old filter forward and away from the tight suction connection. I was concerned that I would be too forceful for the plastic assemblies and would break something; deliberate motions and a steady... read more