Models > GS20B8D3B

GS20B8D3B Maytag Refrigerator - Overview

Get Parts and Repair Help for GS20B8D3B

If you know the refrigerator repair part you need, you can browse the list of all parts on the GS20B8D3B, or you can search by name or part description. You can also find your part by where it is located on the GS20B8D3B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for GS20B8D3B parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$107.31

Ice Maker

This replacement ice maker mechanism does NOT come with a cover, a wire harness, or the mounting hardware. Must be ordered separately.

$2.70

Screw

Sold individually.

$2.70

Screw

This screw is sold individually.

$8.37

Light Rocker Switch

$15.79

Water Fill Cup and Bearing

$2.70

Hose Clamp

$3.51

Door Shelf Retainer

Sold Individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$18.02

Icemaker Shut Off Arm

When the icemaker shut off arm is high enought the ice maker will shut off and no more ice will be made until the level of the ice in the bin drops. Also the ice maker can be turne...

$127.20

Icemaker Auger and Crusher Blade Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Icemaker producing few or no cubes and often leaving "kling-ons" on ice tray

  • Customer: Bernie from Diamond Bar CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 493 of 502 people found this instruction helpful
Interior surface of ice tray felt rough & flaky (coating deteriorated) so cubes would not release.
Unplug appliance.
Remove timer cover by hand pressure @ edge.
Remove single attachment screw & bracket at lower front of icemaker.
Disconnect wiring harness from socket @ rear of compartment.
Tricky part was determining what type of con... read more

Water overflowed ice maker turnning ice bucket into solid mass of ice

  • Customer: Harry from Grand Ledge MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 201 of 272 people found this instruction helpful
My ice maker has been shedding its non-stick coating for over a year. Within the last month of so, it started pouring water into the ice bucket below, turning it into a solid mass of ice. So I purchased a new ice maker assembly. I encountered two problems not mentioned in the 21 or so do-it-yourselfer repair stories that precede this one. First problem: o... read more

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 62 of 75 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more