Models > GMC305PDB6

GMC305PDB6 Whirlpool Oven - Overview

Get Parts and Repair Help for GMC305PDB6

If you know the oven repair part you need, you can browse the list of all parts on the GMC305PDB6, or you can search by name or part description. You can also find your part by where it is located on the GMC305PDB6 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for GMC305PDB6 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$46.96

Inner Door Glass

$36.04

Oven Rack

Sold individually.

$2.70

Screw

This screw is sold individually.

$42.18

Bake Element

$57.61

Glass Cooking Tray

$37.04

Thermal Overload Safety Thermostat

This part establishes and maintains the internal temperature of the oven cavity.

$18.07

2 Piece Broiler Pan

$21.14

Light Bulb - 120-130V - 15W

Sold individually.

$4.65

Touch-Up Paint - White

$64.05

Temperature Sensor

This temperature sensor detects the temperature within the oven cavity.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broke the glass panel inside the oven door -- dropped a baking dish on the glass!

  • Customer: Robert from Wildwood MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 77 of 100 people found this instruction helpful
Easily removed the door from the oven by releasing clips attached to the door hinge -- very nicely engineered. Removed about 6 philips head screws to allow the door assembly to be taken apart for access to the glass. Lifted out the broken glass, cleaned the inside of the door, installed the new glass, reassembled the door (a two minute project), and reatt... read more

No heat after cleaning oven

  • Customer: Frederick from St. Louis MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 52 of 58 people found this instruction helpful
This built-in oven was slid out of it's space and set on a box. I removed the back cover with nut driver and located the safety overload device. removed nuts and used pliers to remove wires and replace them. The power must be off to do this repair.Replaced the cover and slid back into place. This could be a lot more difficult if your power cord or gas line ... read more

Oven buzzed and no heat

  • Customer: Joseph from Saint Charles IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 34 of 39 people found this instruction helpful
First took down the hood/microwave and removed the sheet metal housing.
I changed HV diode as it was the least expensive component and the first one that internet suggested and tested bad with a ohm meter. Didn't fix a thing.
Capacitor failed test with meter so I ordered and then replaced this.
Still no change so I ordered a new magnetron. ... read more