Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GLT3657RB03

GLT3657RB03 Whirlpool Cooktop - Overview

Get Parts and Repair Help for GLT3657RB03

If you know the cooktop repair part you need, you can browse the list of all parts on the GLT3657RB03, or you can search by name or part description. You can also find your part by where it is located on the GLT3657RB03 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.80

Torx Screw

7-18 x 3/4" - sold individually.

$7.97

Knob Skirt - Black

$5.15

Screw, Igniter

This screw is sold individually.

$4.63

Knob Skirt

This part goes around the back of the knob.

$5.15

SCREW

Sold individually.

$4.79

Screw

Sold individually.

$13.19

Surface Ignitor

Also known as Spark Electrode. This part helps your burner ignite and produce flame.

$20.73

White Drip Bowl - 9 inch

Sold individually.

$16.94

Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

$2.80

Screw

This screw is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Igniter problem on one gas burner

  • Customer: Roland from Houston, TX
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 12 of 14 people found this instruction helpful
I had to remove the two separate components of the gas burner unit, each had two screws. I lifted then tilted the lower portion of the burner unit to allow access to the underside of the igniter. I removed the wire and then with an offset screwdriver I removed the single screw that held the igniter in place. I reversed the steps to install the replacement,... read more

I had a faulty wiring on the igniter switches.

  • Customer: Raymundo from Cerritos, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 9 of 11 people found this instruction helpful
replaced the set of igniter switches I order from Partselect .com. read more

one of the cooktop burners would not ignite

  • Customer: Ronnie F from McKinney, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Wrench set
  • 3 of 5 people found this instruction helpful
removed knobs, burnners, top cover plate, disconnecte two gas lines from burnners to controls, lifted burnner bar, unscrewed igniter, installed new ingiter, and then reassembled cooktop. There was a total of ten screws removed, and two gas lines disconnected. The total repair time was about twenty minutes. I ordered the part on line and it was at my home ... read more