Models > GLS3675VS02

GLS3675VS02 Whirlpool Cooktop - Overview

Get Parts and Repair Help for GLS3675VS02

If you know the cooktop repair part you need, you can browse the list of all parts on the GLS3675VS02, or you can search by name or part description. You can also find your part by where it is located on the GLS3675VS02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$5.79

Burner Grate Pads - Kit of 5

These pads go on the bottom of your gas cooktop grates to prevent them from moving and scratching the top of your appliance.

$2.70

Torx Screw

7-18 x 3/4" - sold individually.

$2.70

Igniter Screw

This screw is sold individually.

$3.83

SCREW

$17.76

KNOB

$16.73

Surface Igniter

Also known as Spark Electrode. This part helps your burner ignite and produce flame.

$95.93

Double Burner Grate

$32.03

Burner Cap - Left Rear/Right Front - Coal Matte Black

$38.12

Natural Gas To Liquid Propane Gas Conversion Kit

$56.52

Igniter Switches with Harness

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

several grate pads fell out/lost /broke during cleaning

  • Customer: Sabrina from Mooresville NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 29 of 29 people found this instruction helpful
The only real issue was locating the proper adhesive to ensure that the new pads would not fall out. The small insert paper slip in the package noted that a RTV adhesive should be used. After much searching at the home improvement super store, I learned it would be found at an auto supply store. It is black, and is for high temp use. It is available in a sma... read more

Rubber pads on bottom of grate broke off, grate was scratching stainless steel top

  • Customer: Melissa from The Woodlands TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 13 of 20 people found this instruction helpful
I just put the grate pads in the bottom of the grate. The repair was a snap. read more

Igniter problem on one gas burner

  • Customer: Roland from Houston TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 9 of 9 people found this instruction helpful
I had to remove the two separate components of the gas burner unit, each had two screws. I lifted then tilted the lower portion of the burner unit to allow access to the underside of the igniter. I removed the wire and then with an offset screwdriver I removed the single screw that held the igniter in place. I reversed the steps to install the replacement,... read more