GLMV169DBD Frigidaire Microwave - Instructions

After trying to bend parts that do not bend I realized you need to remove the plastic gasket around perimeter of microwave door but leave it loosely hanging on (pry off with screwdriver) With the gasket removed you can fit the door on and the snap the gasket back in place before closing and testing. The door was a perfect fit, it works great. The door will not go on until you remove or bend back that gasket. It's not obvious how or where to remove but just put a screwdriver in there and you'll feel it pop out and it snaps right back in after assembly..

on the inside of the door we gently pried off the liner to get ot the hinges ,lifted off the old door, place the new one on ,then carefully popped the inside liner back in place. Door fixed

The old door came off easy quick. the new door was a little different. I used a flat head screw driver, popped the bottom hinge in first and I did the same on the top. The top you had to use more pressure and use a little more force to rotate the hinge to the pin hole.

Took longer than it should due to no instructions being in box. The removal of the old door took approx 30 secs and was self explanatory. Once I realized I had to remove the plastic inner panel on the new door to re-install it, it also took only minutes. Could have been an easy fix with instructions.

I found and removed the clip for the door - top on the inside (not easy to find) and then removed the door. Called support who told me to watch you-tube and there were good instructions there. Needed needle nose pliers to hold broken screw and a screw driver that could fit between the metal. Flat head and phillips are required. OH you should try to leave the screw in the hole as getting it back there is a PIA. Took about 20 minutes and I am challenged mechanically. Altogether, not too bad.

OK folks. Take a butter knife and pry the top and pop off the bottom. Literally less than 2 minutes! Simple. Fast. Easy. Fit perfect!