Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Frank
January 16, 2020
What is the power of this microwave?
For model number GLMV168CS1
Hi Frank,
Thank you for your question. This wattage for this microwave is 1000 watts. We hope this helps. Thank you and have a great day.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Donnie
November 30, 2019
My microwave will not heat. Potential parts replacements?
For model number GLMV168CS1
Hi Donnie, please see our article here: https://www.partselect.com/Repair/Microwave/No-Heat/. Thank you for your question and good luck with your repair!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
The "seal" is a clear plastic sheet that forms the inner most layer of the "window" in the microwave door. If it becomes damaged or doesn't adhere properly, steam and other cooking by-products get inside the door itself. That's what happened in my case. As a result, I had to disassemble the entire door to clean the inside of the glass
... Read moreand other parts. If that cleaning had not been necessary, I could have replaced the seal without disassemblying the door.
To replace the seal, I followed these steps: 1. Used my thumb nail to raise a corner of the old seal. 2. Peeled off the old seal. This leaves a perforated metal layer exposed. 3. Cleaned the metal layer to remove residual adhesive from the old seal. 4. Once the metal layer was dry, my wife and I worked together to peel off the "backing sheet" from the new seal. (One side of the seal has adhesive on it - like the sticky side of tape. After you peal the backing off, the sticky side is exposed.) 5. After we CAREFULLY aligned the seal, I held it while my wife slowly and carefully pressed it into place.
Problems to watch out for: The seal is shipped "folded". This causes a crease to form in the plastic seal, which makes it difficult, if not impossible to install it without leaving any raised places. Note that raised areas in the center probably just look bad. But, raised areas around the edge may prevent a proper "seal" and result in steam, etc., getting inside the microwave door. I receved two separate seals and both had a crease. PartSelect reps were very nice, but were not able to correct the problem.
Unscrew the glass lamp cover and replace the bulb. Very simple. The hardest part was to find the bulb. I looked at my local hardware stores but of course they did not have them. This site was great and easy to order. I looked at 3 other sites before finding this one to be the most simplistic to use.