Models > GLGC30S8ASA

GLGC30S8ASA Frigidaire Cooktop - Overview

Get Parts and Repair Help for GLGC30S8ASA

If you know the cooktop repair part you need, you can browse the list of all parts on the GLGC30S8ASA, or you can search by name or part description. You can also find your part by where it is located on the GLGC30S8ASA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the GLGC30S8ASA [Viewing 4 of 4]

$37.39

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$31.02

Igniter Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

$5.71

SCREW

$24.57

Burner Igniter

Also known as spark electrode. This part helps your burner ignite and produce flame.

$137.62

Gas Pressure Regulator

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

$64.95

PAN

$62.66

Drip Pan - White

This pan is actually WHITE. It is not black as the photo suggests. This pan is sold individually.

$59.00

Burner Cap - 9.5K

Sold individually. Gray in color.

$31.05

SUPPORT

$7.04

SCREW

Common Symptoms of the GLGC30S8ASA [Viewing 1 of 27]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas ignitor continued to run after turned on or off

  • Customer: Duff from Buena Vista CO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 5 of 6 people found this instruction helpful
Removed all of the grates, control knobs and gas diffusers. Unscrew the drip pans, two on each pan, which attach the pans to the gas supply. Raised the drip pans from the top and unplugged the ignitors from all pans. Remove the top and the rubber deflector over the ignitor switch. The ignitor switch snaps off and on. One of the seals under the drip pan was b... read more

burner ingnighter would not lite burner

  • Customer: Wayne from Palestine IL
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Wrench(Adjustable)
  • 14 of 46 people found this instruction helpful
Replaced the ingintion module, still did not work, replaced the burner complete with new ingiter , it now works but another one quit . the front right one has 5 ohms resistance ,replaced with new one with 0 ohms, the back left has 2 ohms resistance and now it does not work , will need to replace that burner allso. too bad you can't buy just the spark module ... read more

Two of theTop gas burners would not spark

  • Customer: Robert R from Lewistown PA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Took 6 screws out holding the top on from the sides. Lifted the top front, popped out the spark module, Took 6wires off & reversed the processed to install the new one. I was really amazed when I ordered it Wednesday and it arrived on Friday. Believe me I bookmarked this site. read more