Models > GLEC36S8AQB

GLEC36S8AQB Frigidaire Cooktop - Overview

Get Parts and Repair Help for GLEC36S8AQB

If you know the cooktop repair part you need, you can browse the list of all parts on the GLEC36S8AQB, or you can search by name or part description. You can also find your part by where it is located on the GLEC36S8AQB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the GLEC36S8AQB [Viewing 4 of 4]

$169.66

Dual Radiant Surface Element - 6"/9"

$5.62

SCREW

$145.87

Surface Burner Element with Limiter - 6" - 1200W

$65.14

USE WCI 903097-9050

$280.09

Dual Burner Element Assembly - 1800/2600W

$25.96

LIGHT

$32.84

KNOB

$31.80

KNOB

$31.64

BUSHING

$105.64

Surface Burner Switch

Common Symptoms of the GLEC36S8AQB [Viewing 1 of 81]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned out burner

  • Customer: Lori from Winter Haven FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 30 of 38 people found this instruction helpful
First we removed two screws under the rim of the range top to open the lid. Lifted the lid and removed the screws from the bracket that holds the elements, Be careful with the clips that hold the element in, if you break them or bend them there aren't any more! Also note which holes they were in, they are marked according to the different sizes of element... read more

Burner eye would only produce High Heat on all settings

  • Customer: scot from keller TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 4 of 17 people found this instruction helpful
Ordered a new Surface Burner Switch to replace the failed unit.
When I opened the burner lid, I could see the insulation on all the wiring for the burners had fallen apart and wiring was exposed. The wiring for all 4 burners was exposed as the insulation had deteriorated and fallen off over 80% of the circuits. It was just blind luck there was not a fi... read more

"hot" indicator light on glass cook top burned out

  • Customer: Kathleen from Middlebury VT
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
After removing pots / pans in cabinet below cook top and turning off the power, I was able to remove the panel held by 2 screws. Pulling the old light out was just a little difficult as it came in pieces. New one popped right in, hooked up terminals, replaced the panel and that was it !! read more