Models > GLD6611L20SS

GLD6611L20SS General Electric Dishwasher - Overview

Get Parts and Repair Help for GLD6611L20SS

If you know the dishwasher repair part you need, you can browse the list of all parts on the GLD6611L20SS, or you can search by name or part description. You can also find your part by where it is located on the GLD6611L20SS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for GLD6611L20SS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$9.93

Lower Rear Rack Wheel and Axle Kit

This kit contains one wheel and one axle. It is designed for the rear lower dishrack. Sold individually. Order quantity needed.

$0.69

RACK SLIDE END CAP

This part attaches to the rails, for the upper rack, to prevent the dishrack from sliding all the way out.

$1.21

Wheel Axle

This axle attaches the dishwasher wheel to the rack. Sold individually.

$3.02

Recess Door Spring

$43.36

Detergent Dispenser with Rinse Cap

$46.61

Water Inlet Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. This valve has a 3/8" inlet and comes with the mounting bracket.

$8.64

Door Handle Actuator

$10.04

Middle Spray Arm

$7.27

Switch Interlock

$104.74

Lower Dishrack with Wheels

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lower rack wheel was melted

  • Customer: Mark from Huntingdon Valley PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 463 of 464 people found this instruction helpful
Unsnapped clip,and moved it 90 degrees. Slip wheel and clip off. Installed clip on new wheel. replaced new wheel. The wheel did not come with a new clip and was not suggested on the parts list. The existing clip was still OK but if it was not, I would have had to order a clip and wait. All in all, a good experience. read more

The rear wheels were missing on the lower rack.

  • Customer: Teresa from Phenix City AL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 458 of 460 people found this instruction helpful
The wheels came with a clip on part that clipped to the rack and the wheel snapped into that clip. I am a woman and it was easy for me to do. Thanks to Parts Select for being an easy to use and navigate site, for quick shipment and for good directions with the parts. Sincerely, Teresa from Alabama. read more

Diswasher wasn't cleaning the dishs because the spray arms were clogged with calcium deposits.

  • Customer: Ric from Henderson NV
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 49 of 57 people found this instruction helpful
Replacement of the arms is very simple, the bottom arm pulls out after turning it counter clockwise, no tool needed. The upper arms need the use of a nut driver or simlar tool to remove the hex screws holding them to the water supply tubes. The hardest part of the repair will be removing the top dish tray. This requires twisting the door slide end retainers ... read more