Models > GJSR2080H2WW

GJSR2080H2WW General Electric Washer - Overview

Get Parts and Repair Help for GJSR2080H2WW

If you know the washer repair part you need, you can browse the list of all parts on the GJSR2080H2WW, or you can search by name or part description. You can also find your part by where it is located on the GJSR2080H2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for GJSR2080H2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$4.02

Knob and Clip Assembly

This knob accepts a D-shaped shaft.

$3.76

Tub Dampening Strap

Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.

$3.68

Timer Knob

White in color.

$3.27

Timer Knob Clip

$53.39

PUMP

$2.55

Dial with Compression Ring

$10.52

Drain Hose Extension - 4 1/2' Long

$6.58

V-Style Drive Belt

$3.00

Drain Hose Clip

This clip holds the drain hose to the back of the washer.

$37.23

Dual Action Agitator

This does not come with the fabric dispenser - must order separately or use original part.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The original Knob just fell apart

  • Customer: Irina from Englewood NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 361 of 363 people found this instruction helpful
The repair was so easy when I got the part, I did it myself without any help in 5 seconds! read more

Washing Machine was not draining water from tub.

  • Customer: Gerald from Midlothian VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers
  • 138 of 147 people found this instruction helpful
1. Drained the wash tub by taking the drain hose from the back of the washing machine and dropping it below the tub - water flowed out of hose a lot easier than trying to suck water out of tub using a pump (tried this on the first time I tried to fix washer). (Washing machine on 2nd floor of house and didn't want water running on floor)
2. Removed the... read more

Bearing on the transmission to tub wore out (mostly due to the washer not being level)

  • Customer: Victor from League City TX
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 75 of 90 people found this instruction helpful
The back of the control panel had an instruction pamplet that was very useful. 2 parts did not go as written tho. To "pop" the spinner out, required short 1x4s and a shake/shingle bar to pry it up and the wedging of the 1x4s under it, until enough strain was put on it to "pop" it off. Then the large 1&11/16 nut was a bear. It required a short pipe wrenc... read more