Models > GI15NDXTQ3

GI15NDXTQ3 Whirlpool Ice Maker - Overview

Get Parts and Repair Help for GI15NDXTQ3

If you know the ice maker repair part you need, you can browse the list of all parts on the GI15NDXTQ3, or you can search by name or part description. You can also find your part by where it is located on the GI15NDXTQ3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your ice maker. We’ve also included any installation videos we have for GI15NDXTQ3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.56

Water Tube Kit

This tubing is 1/4'' in diameter and comes with 2 inserts. This tubing may be longer than the original, and may have to be cut.

$52.70

Recirculating Pump - 60Hz

Used with stand-alone ice cube makers.

$2.70

Screw

This screw is sold individually.

$125.91

Ice Cutter Grid Complete Assembly

Used with freestanding ice makers.

$31.02

Bin Thermostat

Used in stand-alone icemakers.

$24.95

Ice Cutting Grid Wire

There is approximately 10'of wire. Note:2 kits are needed to replace both directions.

$13.71

Light Switch

$15.54

Drain Fastener Cap

$42.39

SENSOR

$2.70

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

was not making ice

  • Customer: Richard from North Wilkesboro NC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 17 of 22 people found this instruction helpful
diagnosed no water flow over evaporator checked voltage into pump then checked pump with ohm meter ordered pump and installed by removing access cover and water holding assembly installed new pump replaced water holding assembly and access cover and returned icemaker to service all is well read more

Broken light switch

  • Customer: Randy from Hays KS
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 18 of 28 people found this instruction helpful
Took all the screws out of the plastic shroud that encloses the switch .There only four that I needed to remove, were the two in front where the switches that go,they go in horizontally and two in the back with large washers on them that hold the back to the top of the box that go in vertically.The switch was a snap ( make that two snaps ) the wiring is alm... read more

Grid Assembly had a broken wire and would not separate the ice sheets into cubes

  • Customer: Brad from Bakersfield CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 12 of 15 people found this instruction helpful
I removed the 2 screws on each side of the grid and disconnected the electrical plugs attached to the grid. I slid the broken unit out. I then carefully slid the new unit in making sure not to pinch any of the electrical wires. I replaced the mounting screws, plugged the 3 connectors back into place and turned the ice maker back on. I had ice cubes within a... read more