Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GHD4309L15CS

GHD4309L15CS General Electric Dishwasher - Overview

Get Parts and Repair Help for GHD4309L15CS

If you know the dishwasher repair part you need, you can browse the list of all parts on the GHD4309L15CS, or you can search by name or part description. You can also find your part by where it is located on the GHD4309L15CS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for GHD4309L15CS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$0.77

RACK SLIDE END CAP

The rack slide end cap is the part that attaches to the rails of your upper dish rack and prevents the dishrack from sliding too far. If you find the dish rack is causing the door ...

Order within the next 9 hrs and your part ships today!
$21.74

Lower Rack Wheel Kit - 8 Pack

This lower rack wheel kit includes 8 wheels and 8 axles that allow the lower dishwasher rack to slide in and out smoothly. If your dishwasher door will not close, is noisy when operating, or the dishes are not cleaning properly, you might need to replace one or more of the wheels. Each wheel and axle are made of plastic, and fit into one another so they can be clipped on to the lower dishwasher rack. Many of our customers found this repair to be quick and easy, and the only tool you should need to complete the repair is a pair of pliers.

Order within the next 9 hrs and your part ships today!
$3.42

Recess Door Spring

Order within the next 9 hrs and your part ships today!
$47.04

Detergent Dispenser with Rinse Cap

This detergent dispenser assembly is attached to the inner door panel of a dishwasher. This part holds detergent and dishwasher rinse products in a covered container. If your dispenser will not open, close, dispense detergent properly, or the dishes are coming out of the dishwasher dirty, replacing this part can solve these problems. The tools needed for this installation project are a #2 Phillips screwdriver and needle-nose pliers. To repair, first remove screws from the bottom of the inner door panel. Next, remove connecters, wires, and screws from the dispenser to access it and replace with new dispenser. Refer to the manual provided by the manufacturer for further installation instructions and guidance. Unplug dishwasher from power source as a safety precaution.

Order within the next 9 hrs and your part ships today!
$15.87

Silverware Basket

The silverware basket, used for dishwashers, is in the bottom of the dishrack. The basket is used to hold eating utensils such as spoons, forks, and knives. If the basket is worn o...

Order within the next 9 hrs and your part ships today!
$10.64

Door Handle Actuator

Order within the next 9 hrs and your part ships today!
$55.61

Water Inlet Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the d...

Order within the next 9 hrs and your part ships today!
$8.68

Switch Interlock

Order within the next 9 hrs and your part ships today!
$4.33

Hinge Arm Link

Order within the next 9 hrs and your part ships today!
$11.69

Middle Spray Arm

Order within the next 9 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lower rack wheel was melted

  • Customer: Mark from Huntingdon Valley, PA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 484 of 492 people found this instruction helpful
Unsnapped clip,and moved it 90 degrees. Slip wheel and clip off. Installed clip on new wheel. replaced new wheel. The wheel did not come with a new clip and was not suggested on the parts list. The existing clip was still OK but if it was not, I would have had to order a clip and wait. All in all, a good experience. read more

The rear wheels were missing on the lower rack.

  • Customer: Teresa from Phenix City, AL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 463 of 467 people found this instruction helpful
The wheels came with a clip on part that clipped to the rack and the wheel snapped into that clip. I am a woman and it was easy for me to do. Thanks to Parts Select for being an easy to use and navigate site, for quick shipment and for good directions with the parts. Sincerely, Teresa from Alabama. read more

soap door latch broken, wouldn't hold soap for later release in middle of cycle like it was supposed to.

  • Customer: James from Naperville, IL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 89 of 94 people found this instruction helpful
Turned off power to unit, 'cuz it has a solenoid lead to open the soap door.
Removed the phillips head screws that held the door together. The screw are located on the inside edge of the door, there are 10-12 of them.
Spearated the door shells carefully, trying not to disturb the location of the wiring in the middle of the door.

Found... read more