Models > GH5184XPS4 > Instructions

GH5184XPS4 Whirlpool Microwave - Instructions

All installation instructions for GH5184XPS4 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the microwave repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the GH5184XPS4
31-45 of 125
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave Turntable Won't Rotate

  • Customer: Steven from Sacramento, CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 6 of 12 people found this instruction helpful
I turned off the power to the oven at the breaker. I then removed the side trim pieces by removing the screws located behind the lower oven door. I removed the plastic trim pieces above and below the microwave oven and removed the control panel and slid it into the opening above the microwave. I located the two screws securing the microwave into the frame and began sliding it out. I had to disconnect a small wiring harness and two wires from the microwave that were attached inside the opening above the microwave. The microwave section was the easily slid out, turned on it's side where the turntable motor was accessed by removing the access panel. I pulled the old motor, checked resistance and it matched the new motor. I then checked the old motor by applying 120V to it and it ran FINE! I thought I had the wrong part, but decided to install the new motor anyway. I did, secured the access panel and replaced the microwave in the frame. I reconnected the wires and secured the control panel and tested the microwave...and the turntable works!

Broken vent grille.

  • Customer: Claude from Maramar, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 3 of 4 people found this instruction helpful
It was very easy, no tools needed. I simply snapped the new part into the self aligning grooves.

Broken Vent Grille for the microwave

  • Customer: Ron from Summerville, SC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 3 of 4 people found this instruction helpful
Thanksgiving night, I found a rather large crack in the grille and it wouldn't stay in place. I placed the order for the replacement grille on Friday and received the new grille Monday. It just snapped in place, no tools necessary. I had contacted the Sears parts replacement department and all I got was attitude from the parts "help" desk. I'm glad I placed the order with Parts Select, the cost was cheaper and shipping was faster. I won't hesitate to use Parts Select the next time I need a part for any of my Whirlpool appliances.

glass turntable broke in half, ring turn needed replaced

  • Customer: Gail from Cincinnati, OH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 3 of 4 people found this instruction helpful
I removed the broken tray and ring-turn and replaced it with the new
Service was fantastic, parts were ordered one day and received the next

Turntable coupling

  • Customer: Laura from Port St Lucie, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 3 of 5 people found this instruction helpful
Rep knew exactly what I needed when I described where the part should go on my microwave - price great - shipping great - installed in seconds. Thank you!

grill broke

  • Customer: Patricia from Brick, NJ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
just snapped top in,
Service was excellent, could not get any better service.

Microwave vent grill broken

  • Customer: Mark from Corpus Christi, TX
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
Unpacked the replacement and popped it into place.

Original vent grille clips broke off, so the grille would not stay on.

  • Customer: Frances from Happy Valley, OR
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
Just installed the new grille in place of the old one. (That is after I received the correct one, since I initially ordered a white one which definitely did not go with my stainless microwave!)

Microwave vint was broken

  • Customer: Basma from Charleston, AL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 3 of 6 people found this instruction helpful
Was really easy I removed the old one and install the new one in just one minute.

replacement of charcoal filters in microwave

  • Customer: Hendrika from Campbell, CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
This wasn't really a repair, just an replacement of the filters, which is a regular maintenance requirement.

Old part would not stay on due to broken clip base

  • Customer: Richard from League City, TX
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 2 of 3 people found this instruction helpful
Ordered new part on Thursday night and new part arrived the following Monday. After unpacking I just snapped the new grille in place and the job was done. I was really impressed with the quick service that I received from PartSelect.

Vent grille broke

  • Customer: Taylor from Jacksonville, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
removed old grill and snapped new one in place. Quick delivery thanks

Grill Broke

  • Customer: Andrew from Carlsbad, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 2 of 3 people found this instruction helpful
SO EASY... It just clipped right in...

vent grille was damaged and would not stay on.

  • Customer: Beau from Cary, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 2 of 4 people found this instruction helpful
easy squeasy, lemon-peasy. Took all of 15 seconds. Opening the box took longer than installing the vent. It just snaps right in place.

broken grill

  • Customer: Jesse Ralph from Robbinsville, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 1 people found this instruction helpful
Very simple just fit in the groves and snaped it in. I had ordered 1 from another Compaany that would not fit and was almost twice the price, got my money back but had to pay shipping Will use partSelect.com for any other parts.
All Instructions for the GH5184XPS4
31-45 of 125