Quick Question!

Have you ever purchased from PartSelect.com before?

Models > GH5184XPQ3 > Parts

GH5184XPQ3 Whirlpool Microwave - Parts

All parts for the Whirlpool Microwave GH5184XPQ3

Below is a list of all parts for the Whirlpool Microwave GH5184XPQ3 - Hood Combo. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the GH5184XPQ3
1-14 of 120
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$47.68

Glass Cooking Tray

This a genuine OEM microwave cooking tray. It is also known as a microwave turntable or microwave plate. The function of the tray is to hold and rotate food items while the applian...

$7.86

Grease Filter

This grease filter, used in microwaves, can be located underneath the microwave. The filter traps grease from the exhaust air and removes it from the air stream. This helps prevent grease sticking to the inside of the exhaust hood. Please note that most microwaves require two grease filters and they are both sold separately. This is an easy replacement done by simply pulling out old filters and sliding in the new ones. For further instructions and guidance, refer to the manual provided by the manufacturer. Unplug the microwave from the power source before starting this installation.

$28.77

Vent Grille - Stainless

This part is plastic with a stainless color finish and comes with the clips needed to mount the grill. The actual stainless steel option is no longer available.

$30.05

Vent Grille - Black

This vent grille mounts on the top of the microwave above the door.

$6.98

Filter - Single

Sold individually.

$8.40

Fuse

If your microwave is not turning on it could be due to your fuse needing to be replaced. This part protects the microwave by shutting it off if there is an electrical surge. This fuse is just over an inch long, is metallic on both ends and ceramic in the middle. Before beginning this repair, unplug the appliance and wait a few minutes before starting. Remove the outer cabinet which is held in place with two screws. You will then locate the power cord which will lead you to the fuse holder. Determine if the fuse has blown. Using an ohmmeter, you should be able to figure out if it has blown. A proper reading is zero ohms, if it reads as anything else then your fuse has in fact blown. Simply snap the old fuse out of place and place the new one in.

$2.90

Top Mounting Screw

This screw is sold individually.

$4.50

CLIP

Sold individually.

$18.95

Drive Coupling

This is an authentic manufactured drive coupling for a microwave. It fits on the motor shaft to hold and rotate the glass turntable tray while the appliance is running. This part h...

$3.02

SCREW

Sold individually.

$54.59

Door Handle - Stainless Steel

Handle only.

$30.05

Vent Grille - White

Clips are NOT included. - This vent grille mounts on the top of the microwave above the door.

$26.47

Door Switch - 250V

This door switch (Primary and Secondary) keeps the microwave from running when the door is open. NOTE: Two switches required. Sold individually.

$56.97

Door Handle - Black

Handle ONLY.

All Parts for the GH5184XPQ3
1-14 of 120