GH4184XSB0 Whirlpool Microwave - Instructions

Rep knew exactly what I needed when I described where the part should go on my microwave - price great - shipping great - installed in seconds. Thank you!

Husband replaced the bulb

Replaced the supports and rack.

With new replacement grill, a separate clip was supplied in the box that had to be screwed in to the top portion. This clip did not fit since the hole for the screw was on the right side and not the left, so I just snapped the grill in place with the existing clips.
There must be another clip that fits this unit but perhaps the person packing the box grabbed the wrong clip and taped it in with the shipped box.

Removed turntable
Place support ring in track
Place turntable on support ring.
Easy, peasy!

just snapped top in,
Service was excellent, could not get any better service.

Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!

E. Robinson

removed old grill and snapped new one in place. Quick delivery thanks

Unpacked the replacement and popped it into place.

SO EASY... It just clipped right in...

Just installed the new grille in place of the old one. (That is after I received the correct one, since I initially ordered a white one which definitely did not go with my stainless microwave!)

Was really easy I removed the old one and install the new one in just one minute.

If you buy a used microwave, be sure the mounting plate is with it. Buying one is always more than $25 bucks and takes time.

easy to replace, just the same as cleaning the turntable and placing back in the micorwave;

Remove the two screws to the plastic vent strip at the top of the unit. That exposes a metal cover (upper right) held in place by two more screws. (Found that removing the screw holding the key panel in place and moving that out of the way made for more work room) Remove the metal cover. The HV diode (visible) on one end is secured to the chassis by a screw. The other end is fitted to the HV capacitor. So unscrew one end and pull the HV diode off the capacitor. The replacement fits on like the old one came off. Very simple repair. But it would be safe to short the capacitor terminals to the chassis first. Noticed that it appeared the sparking was caused by the HV diode's outer casing being worn by the asbestos covered wire next to it and laying against it. I made sure the two were not touching, before putting the covers back on. Also, the problem started with an occasional spark when the MW started. It quickly deteriorated to a full, non-stop electrical sparking. You can hear it, smell it, and see it through the top vent. You don't need to remove unit to work on it.